Audiovox CE531MP Operating Instructions

TO PLAY MP3 (for remote only)
This set can read MP3.
1. Press the FUNCTION button to CD.
2. To open CD door. Place a MP3 disc in the center with the label face front. The
total albums and the total tracks appear on the display.
3. Press the PLAY/PAUSE button to start play.
4. Press the STOP button to stop playback.
5. In stop mode, press PLAY/PAUSE button to start playback.
TO SEARCH AN ALBUM
Basically this system supports the album search mode to search an album at high-
speed.
1. Press the PRESET + / ALBUM + or PRESET – / ALBUM – button to search a desired
album in play /stop mode.
2. After selected a desired album, the first track of this album will be shown on the
display within two seconds.
3. Press the SKIP/SEARCH / button to search a desired track and then press
the PLAY/PAUSE button to play the track.
4. During searching the album, the album number is shown on the display.
SEARCH A FILE (SONGS) BY FILE NAME
1. Press the MP3 MODE button once the " " will blink, the file name and the
number's tracks appear on the display.
2. Press the SKIP/SEARCH / buttons one by one to find the file name, the
file name will display sequence as "A,B ........... Z, 0 .......... 9".
3. Press the SKIP/SEARCH / buttons about 2 seconds, the capital letters or
the figure will blinks. If the first letter of the file name in this disc haven't the
capital letters or the figure, it will not blink.
4. Press the SKIP/SEARCH / buttons one by one to search file.
5. Press the PLAY/PAUSE button to play select file.
SEARCH A FILE (SONGS) BY ALBUM
1. Press the MP3 MODE button twice times, the " " will light and ALBUM appear
on the display.
2. Press the SKIP/SEARCH / buttons one by one, to select album.
3. Press the SKIP/SEARCH / buttons about 2 seconds until "ALBUM" disappear.
4. Press the SKIP/SEARCH / buttons one by one to search file.
5. Press the PLAY/PAUSE button to play select file.
1. FM MONO / STEREO / MP3 MODE /
1
CD ESP ON/OFF button
2. STANDBY/ ON button
2
3. FUNCTION (CD/AUX/TUNER) button
3 10
4. PRESET+ / ALBUM+ button
4
5. STOP / BAND button
11
5
6. TUNING / SKIP / SEARCH button
12
6
7. MEMORY button
13 8. PRESET– / ALBUM– button
7
9. SLEEP button
14
8
10. REPEAT button
9 15 11. PLAY / PAUSE button
12. TUNING / SKIP / SEARCH button
13. X-BASS button
16
14. RANDOM button
15. TIMER button
16. VOLUME +\– controls
USING THE REMOTE CONTROL CORRECTLY
• Point the Remote Control at the REMOTE SENSOR located on the unit.
• When there is a strong ambient light source, the performance of the infrared
REMOTE SENSOR may be degraded, causing unreliable operation.
• The recommended effective distance for remote operation is about 6 meters (19
feet).
TO CHANGE REMOTE BATTERY
1. Open the battery 2. Insert one CR2025 (3V) ATTENTION
Take out the PVC sheet
door. size battery.
before operating
the Remote
Control.
BATTERY REPLACEMENT
When battery become weak, the operating distance of the Remote Control is greatly
reduced and you will need to replace the battery.
NOTE : If the Remote Control is not to be used for a long time, remove the battery to
avoid damage caused by battery leakage corrosion.
WARNING : Do not dispose of batteries in fire, batteries may explode or leak.
CAUTION : Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
PROGRAMMING TRACKS - in the MP3 stop mode (Up to a maximum of
64 tracks)
1. Press the MEM button, the ALBUM blinks on the display.
2. Press the SKIP/SEARCH / buttons to select the desired albums.
3. Press the MEM button, the FILE (SONGS) blinks on the display.
4. Press the SKIP/SEARCH / buttons to select the desired files (songs).
5. Press the MEM button again.
6. Repeat alone step 2 and 5 procedure to program additional tracks. Press PLAY/
PAUSE button to start playback of the programmed tracks and memory
indicator will appear on display.
To check the program
While in the stop mode, press the MEM button. The album , file (songs) and
program numbers will appear on the display.
Press the MEM button again to view the other programmed selections.
These displays do not appear during programmed play.
To play the programmed tracks
Press the PLAY/PAUSE button.
To stop programmed play
Press the STOP button, if you want to recover programmed play. You can first press
MEM button and then press PLAY button again.
To clear the memory content
Press the STOP button and then open the CD door or press MEM
then press the STOP button in stop mode.
TO REPEAT PLAY THE ALBUM (in MP3 Mode) (for remote only)
Press the REPEAT button three times to repeat the album, the repeat album
indicator will light.
TO CANCEL REPEAT PLAY
Press the REPEAT button until "REPEAT & ALBUM" indicator is switched off.
CARE & MAINTENANCE
CLEANING CD
If the CD skips or will not play, the disc may need cleaning.
Before playing, wipe the disc from the centre out with a
cleaning cloth. After playing, store the disc in its case.
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly wiping with a soft
cloth.
IMPORTANT NOTICE:
• Should the CD door be opened before the reading of the CD is completed,
a jamming noise may occur. This can be resolved by closing the CD door
and then setting the FUNCTION switch temporarily to AUX.
• If an abnormal display indication or an operating problem occurs, disconnect
the AC power cord. Wait at least 5 seconds, then reconnect the AC power
cord.
• Before transporting the unit, remove the disc from the CD tray.
TROUBLE SHOOTING TIPS
Problem
Solutions
System does not turn on • Make sure AC power plug is secure in the
outlet, and outlet has power.
• Make sure FUNCTION switch is set to CD.
Disc in place but unit
won't play • Make sure disc label is facing up.
• Make sure disc is clean.
• Pause mode is activated.
• Disc may be damaged or dirty; check disc.
Disc skips • Make sure the unit is on a secure spot.
Vibration or jarring can cause the disc to
skip.
Poor FM reception • Make sure FM antenna wire is unwound.
• Electrical interference in your home can
cause poor reception. Move the unit away
from sources of interference (especially
those with motors and transformers).
• Set the AM/MW loop antenna to a direction
Poor MW reception
for the better reception.
REPEAT PLAY (for remote only)
This function will allow a single tracks or all the tracks on the disc to be played
repeatedly.
TO REPEAT THE SAME TRACK TO REPEAT THE WHOLE DISC
Press the REPEAT button once during Press the REPEAT button a second
playback, the repeat one indicator time to repeat all tracks, the repeat
will light. all indicator will light.
TO CANCEL REPEAT PLAY
Press the REPEAT button until "REPEAT" indicator is switched off.
RANDOM PLAY (for remote only)
All the tracks on the disc can be played in random order.
Press the RANDOM button.
RANDOM appears in the display and the disc will play automatically.
button and
TO CANCEL RANDOM PLAY
Press the STOP or RANDOM button so that "RANDOM" in the display goes
out.
SAFETY PRECAUTIONS
Follow the advice below for safe and appropriate operations
ON PLACEMENT
• Do not use the unit in places which are extremely hot, cold, dusty or
humid.
• Place the unit on a flat and even surface.
• Do not restrict the air flow of the unit by placing it in a place with
poor air flow, by covering it with a cloth, or by placing it on a carpet.
• To avoid magnetized. Do not place the unit near speaker or magnet.
• Do not place any naked flame sources, such as lighted candles, on
the apparatus.
• Do not use this unit in direct sunlight or leave the unit in a closed
automobile (or yacht, etc.) where it would be exposed to high
temperatures above 40°C.
• It also should not be placed in temperatures less than 5°C (41°F) or
greater than 35°C (95°F).
ON SAFETY
• When connecting and disconnecting the AC cord, grip the plug and
not the cord itself. Pulling the cord may damage it and create hazard.
• When you are not going to use the unit for a long period of time,
disconnect the AC power cord.
• When the cord is plugged in, a small amount of current continues to
flow to the unit, even when the power is turned off.
• When the AC power cord is connected, the standby indicator will
light up.
NOTES ON BATTERIES
• When discarding batteries, environmental problems must be
considered and local rules or laws governing the disposal of these
batteries must be followed strictly.
ON AC VOLTAGE
• Before use, check that the rated voltage of your unit matches your
local voltage.
FCC INFORMATION
This device complies with part 15 of FCC Rules. Operations are subject
to the following two conditions:
(1) This device may not cause harmful interference, and
MICRO MP3 / CD MUSIC SYSTEM

OPERATING INSTRUCTIONS

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash and WARNING: TO REDUCE THE RISK The exclamation point
arrowhead within the OF ELECTRIC SHOCK, DO NOT RE- within the triangle is a
triangle is a warning MOVE COVER (OR BACK) NO warning sign alerting
sign alerting you of USER-SERVICEABLE PARTS IN- you of important in-
"dangerous voltage" S I D E . R E F E R S E R V I C I N G T O structions accompany-
QUALIFIED SERVICE PERSONNEL. ing the product.
inside the product.
CAUTION : Use of any controls, adjustments, or procedures other than those speci-
fied herein may result in hazardous radiation exposure.
WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION : The apparatus shall not be exposed to rain, moisture, dripping or splash-
ing and the no objects filled with liquids, such as vases, shall be placed
on the apparatus.
CLASS 1 LASER PRODUCT
CAUTION
CLASS 1 LASER
P R O D U C T INVISIBLE LASER RADIATION WHEN
APPAREIL Á LASER
OPEN AND INTERLOCKS DEFEATED.
DE CLASSE 1 AVOID EXPOSURE TO BEAM
This product contains a low power laser device.
(2) This device must accept any interference received, including
interference that may cause undesirable operations.
ON CONDENSATION
• When left in a heated room where it is warm and damp, water droplets
or condensation may form inside the CD player.
• When there is condensation inside the unit, it may not function
normally.
• Let it stand for 1 to 2 hours before turning the power on, or gradually
heat the room up and dry the unit before use.
VENTILATION WARNING
• Do not block the ventilation openings or holes. (If the ventilation
openings or holes are blocked by a newspaper or cloth, etc., the heat
may not be able to get out.)
RATING PLATE LOCATION
The rating plate location is on the bottom of product.
Should any trouble occur, disconnect the AC power cord and refer servicing to
qualified personnel.
Specifications may be subject to change without notice.
Printed in China 811-6938A1-010