Assembly; Unpack Generator; Install Wheel Kit - Briggs & Stratton PowerBoss PowerBOSS 5600 Watt Portable Generator Operator's Manual

Powerboss 5600 watt portable generator operator's manual
Table of Contents

Advertisement

Available languages

Available languages

Assembly

Read entire operator's manual before you attempt
to assemble or operate your new generator.
Your generator requires some assembly and is ready for use
after it has been properly serviced with the recommended
fuel and oil.
If you have any problems with the assembly of your generator,
please call the generator helpline at (800) 743-4115. If calling
for assistance, please have the model, revision, and serial
number from the data tag available. See Generator Controls
and Features for data tag location.

Unpack Generator

1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.
The generator is supplied with:
• Operator's manual
• Oil bottle
• Wheel kit

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 13 mm wrench
• Socket wrench with a 13 mm socket
• Pliers
• Safety glasses
J
K
H
E
Install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle (A) through both mounting brackets.
3. Place a wheel (B) on each side as shown below.
4. Place a washer (C) on axle and then place an e-ring (D)
in axle groove.
E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Always wear eye protection when installing/removing e-rings.
5. Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
6. Repeat steps 4 and 5 to secure second wheel.
7. Tip generator so that engine side is down.
8. Line up holes in support leg (E) with holes in generator
frame.
9. Attach support leg using two short capscrews (M8 x
25 mm) (F) and two locking hex nuts (G). Tighten with
a 13 mm socket and wrench.
10. Center handle (H) on generator frame as shown and
attach with M8 x 45 mm capscrews (J) and M8 lock
nuts (K).
11. Return generator to normal operating position (resting
on wheels and support leg).
A
F
G
CAUTION
B
C
D
7

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents