Table of Contents
Advertisement
Step 4. Replace the top cover by inserting the tabs into the slots on the
bottom of the case.
Step 5. Insert the four screws provided in the places indicated and tighten
the screws in place. Once this is complete, the top cover, hard
disk drive and bottom case will be held securely together.
Step 6. Rotate and insert the rubber plugs into their original positions to
cover up the exposed screw heads.
Step 7. You are now ready to use your EZ-Bus-DT. You will need to
initialize your new hard drive, instructions for this are on page
17.
www.apricorn.com
6
Advertisement
Table of Contents
