AMX PSN4.4 Specifications

NOTICE: This drawing is the UNLESS OTHERWISE SPECIFIED:
property of AMX Corporation.
TOLERANCE ON DECIMAL DIMENSIONS: XX = .010
All information contained herein
XXX = .005
that is not generally known
TOLERANCE ON HOLE DIAMETERS:
UNDER .250 ú = +/- .005
shall be confidential except
.250 TO .500 = +.006 -.005
to the extent the information
OVER .500 = +.008 -.005
has been previously established.
FRACTIONAL DIMENSIONS INCLUDING HOLES: +/- 1/64
This drawing may not be copied, ANGLES: +/- 1.0°
SURFACE FLATNESS .003 TIR PER LINEAR INCH.
reproduced, or used as the basis
ALL DIMENSIONS IN INCHES.
for manufacture or sale without
DO NOT SCALE THIS DRAWING.
written permission.
REV ECN
A 5492 RELEASE TO PRODUCTION
B 5566 REMOVE NOTE
REL APPR REL DATE REV APPR
NOTICE: This drawing is the
DAS 10/16/03
property of AMX Corporation. DRAWN
All information contained herein
DB 10/21/03 DB
ENGR SERV
that is not generally known
RDR 10/21/03 PL
ENGINEER
shall be confidential except
to the extent the information KZ 10/21/03 KZ
PROD ENGR
has been previously established.
MD 10/21/03 KL
MATL SUP
This drawing may not be copied,
AK 10/21/03 AK
SIZE
reproduced, or used as the basis QUALITY
for manufacture or sale without
THIRD ANGLE
written permission.
PROJECTION
95-0423-45-B
REVISIONS
DESCRIPTION DATE APPROVED
10/21/03
11/4/03
TM
PICTORIAL,
PSN4.4 POWER SUPPLY
13.5VDC 4.4A, SHOWN USING A
3MM MINI PHOENIX CONNECTOR
SCALE DWG. NO. REV.
95-0423-45
B FULL B
1 OF 1
SHEET