Sensormatic
SENSORVISION SYSTEMS
Installation Instructions
Parts
Description
PCB ASSY, VIDEO
MGR2, TEXT OVERLAY
The following steps are the procedures for the
installation of the Text Overlay Board:
1.
Shut the console OFF and uplug the power cord.
2.
Remove the left top cover (a) located over the
video output board (b) as shown in diagram 1 .
3.
Remove the appropriate video output board by
loosening the lower mounting screw and gently lifting
up on the BNC bracket (c) until the board disengages
from the motherboard connector (d) . Move the
board slightly toward the rear of the unit until it
disengages from the backplane connector (e) . Lift
the board from the unit. Refer to diagram 2.
4.
Refer to Diagram 3 for connecting the correct text
overlay board to the correct connectors on the video
output board and setting the appropriate jumper pins.
Insert the top edge connector (a) on the video
5.
output board into the backplane connector while
aligning the two bottom edge connectors (b) with the
motherboard connectors as shown in Diagram 4 .
V8000-0750-01 Rev A
8000-0750-01 Rev A1
®
Q t y.
Part No.
1
0301-0337-01
WARNING
DISCONNECT AC POWER TO
THE VM2000 CONSOLE.
CAUTION
SENSITIVE COMPONENTS!
FOLLOW PROPER HANDLING
PROCEDURES TO PREVENT
COMPONENT FAILURE.
1
b
a. left top cover
b. video output board
2
c
c. BNC bracket
d. motherboard connector
V
M
2000
IDEO
ANAGER
Text Overlay Board
SHOCK HAZARD!
STATIC
a
e
d
e. backplane connector
VM2000 Text Overlay Board
1-1