Stopping The Brew Process; Brewing Hot Water; Refilling The Water Tank - Breville BKC600XL User Manual

BR9013 BKC600XL_IB_AMEND.qxp
continued
', however
The My K-Cup ® accessory is designed for
brewing
ground coffee only. Do not:
t 60
a) Use a K-Cup ® or coffee pod in the My
remove
b) Use the My K-Cup ® Filter Basket with the
Cup ®
After brewing with the My K-Cup ® accessory,
oid risk
the K-Cup ® Holder must be inserted into the
Arm or
Brewing Chamber in order to brew a K-Cup ® .
ewing
To replace the K-Cup ® Holder, raise the Safety
Locking Arm, and remove the My K-Cup ® Holder.
ndicate
Insert K-Cup ® Holder into the Brewing Chamber,
for the
15
aligning the arrow
sound.
with the arrow
Use caution when doing this as there is a sharp
needle on the underside of the Brewing Chamber
Note
Head that punctures the K-Cup ® .
he
tion as

Stopping the brew process

removing
To stop brewing after the process has started, press
ckwise
m the and release the Power Switch on the right side of the
Brewer to the 'OFF' status. The flow of coffee, tea or
ut the
hot cocoa will stop, the heating element will shut off
and the LED's illuminating the Water Tank will no
tea or
longer be lit. The LCD screen will indicate the time,
'ON-OFF TIME' and 'AUTO OFF'. None of the control
panel buttons will be active until the Brewer is turned
back on.
You may get less coffee, tea or hot cocoa during
your next brew. After a terminated brew, we
recommend that you follow the instructions for
Brewing hot water (page 15). Your next brew will
then dispense the correct volume according to
the brew size you have selected.
K-Cup™ Filter Basket.
K-Cup® Holder
on the K-Cup ® Holder
in the Brewing Chamber.
11/10/07 21:43 Page 15

Brewing hot water

The Brewer is able to dispense a cup of hot water
for making hot chocolate in a packet, for use in
cooking, for making soups, etc. Follow the
instructions Brewing a K-Cup ® (page 10), without
inserting a K-Cup ® .
After brewing a hot cocoa K-Cup ® , or stopping
the brew process mid-cycle, we recommend
running a hot water brew cycle.

Refilling the water tank

The LCD screen will indicate 'REFILL TANK' when the
water level in the Water Tank is low or if the Water
Tank has been removed.
1. Fill the Water Tank with water until it is
approximately 1 inch below the top edge.
Note
The Water Tank can be filled in two ways:
a) Remove the Water Tank Lid and pour water
directly into the Water Tank while it is still
attached to the Brewer, then replace the Lid.
b) Remove the Water Tank Lid, then gripping the
handle located on the left side of the Water
Tank, lift upwards. Fill with water. Place the
Water Tank back onto the Brewer and replace
the Lid.
2. The LCD screen will indicate either:
a) 'OPEN HEAD'. Raise and lower the Safety
Locking Arm completely.
b) 'HEATING' as the Brewer heats the water for
the next brew cycle. This process lasts about
15 seconds. The pump will make a vibrating
sound. This is normal.
3. Once the Safety Locking Arm is opened and
lowered, or the water is heated, the LCD screen
will indicate 'READY TO BREW', indicating the
brew cycle can begin. The
Note
will illuminate and the 'BREW' button will
illuminate and flash for up to 60 seconds.
Note
and buttons
15