Page 1
ACRYLIC SHOWER RECEPTORS INSTALLATION INSTRUCTIONS These Installation Instructions apply to HYTEC Shower Receptors with a thermoformed Acrylic surface. They are backed with fibreglass-reinforced plastic for strength and durability. All models have a textured floor. Centre of Drain Centre of Drain Overall Model Length...
Page 2
Centre of Drain Centre of Drain Overall Model Length Depth Threshold Height from Side from Rear Height 60” 41 7/8” 9 5/16” 20 1/4” 3 3/4” 2.5” ACR3790L/R 1524mm 1064mm 241mm 521mm 95.25mm 63.5mm 42” 48” 21” 5 7/8” / 4 ½” * 4 3/8"...
PLANNING AND INSTALLATION All shower receptors should be supported from the underside with mortar or grout. Ensure that drain plumbing does not protrude too far above the building floor and that there are no objects such as large aggregate between the building floor and the shower bottom which would result in upwards pressure against the floor.
DRYWALLING After the Receptor is in place and secured, proceed with the installation of drywall (green in the figures below). If tile or another finishing surface is being used, butt the bottom of the drywall up to the top of the sealing flange. The tile can then project over the edge of the drywall, down to the deck on single flange models, or down to the horizontal ledge on double flange models (See Figures 1 and 2).
To obtain warranty service, contact Hytec Customer Service at (800) 871-8311 or (250) 546-3067, or email hytec.customer.service@kohler.com. Please have ready all pertinent information regarding your claim, including a complete description of the problem, the product, model number, serial number and a copy of your original invoice. If the serial number is not available, please provide a digital photo of the unit.
This manual is also suitable for:
Hytec acr3770/ltHytec acr3770dta/bHytec acr3771/ltHytec acr3772/ltHytec acr3773/ltHytec acr3774/lt...
Show all