Fcc Declaration Of Conformity - Toshiba 50L2200U User Manual

Integrated high definition led television
Hide thumbs Also See for 50L2200U:
Table of Contents

Advertisement

6
2) Remove the screws shown in the below diagram.
This will allow removal of the pedestal stand.
3) Once you have removed the screws holding the
pedestal stand in place, remove the pedestal stand
from the TV.
50" TV
VESA Mounting Pattern
Four screws
(Sample illustration)
CAUTION: Always place the TV on the floor or a
sturdy, level, stable surface that can support the
weight of the unit. To secure the TV, use a sturdy strap
from the hook(s) on the rear of the TV to a wall stud,
pillar, or other immovable structure. Make sure the
strap is tight, secure, and parallel to the floor.

FCC Declaration of Conformity

Compliance Statement (Part 15):
Toshiba 50L2200U Television model complies with
Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
The party responsible for compliance to these rules is:
Toshiba America Information Systems, Inc.
9740 Irvine Blvd., Irvine, CA 92618.
Ph: 800-631-3811
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
Hook
equipment generates, uses, and can radiate radio
Sturdy strap
frequency energy and, if not installed and used in
(as short as possible)
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by removing and applying
power to the equipment, the user is encouraged to try
to correct the interference by one of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
• Connect the equipment into an outlet on a circuit different
• Consult the dealer or an experienced radio/TV technician
Caution: Changes or modifications to this equipment
not expressly approved by Toshiba could void the
user's authority to operate this equipment.
receiver.
from that to which the receiver is connected.
for help.

Advertisement

Table of Contents
loading

Table of Contents