Printing A Demo Page; Supplied Software - Samsung CLP-320N User Manual

Clp-320 series color laser printer
Hide thumbs Also See for CLP-320N:
Table of Contents

Advertisement

getting started
2.
This chapter gives you step-by-step instructions for setting up the USB connected machine and software.
This chapter includes:
Setting up the hardware

Printing a demo page

Supplied software

Setting up the hardware
This section shows the steps to set up the hardware as is explained in the
Quick Installation Guide. Make sure you read the Quick Installation Guide
first and follow the steps below.
Location
1. Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow
extra space to open cover(s) and tray(s).
The area should be well ventilated and away from direct sunlight or
sources of heat, cold and humidity. Do not set the machine close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the
altitude setting to optimize your printing (See "Altitude adjustment" on
page 50).
Place the machine on a flat, stable surface so that there is no incline
greater than 2 mm (0.08 inch). Otherwise, printing quality may be
System requirements
Installing USB connected machine's driver
Sharing your machine locally
affected.
2mm
(0.08 in)
2. Unpack the machine and check all the enclosed items.
3. Remove tape holding the machine securely.
4. Load paper (See "Loading paper in the tray" on page 54).
5. Make sure that all cables are connected to the machine.
6. Turn the machine on (See "Turning on the machine" on page 27).
This machine will not operate when the power main fails.
Printing a demo page
Print a demo page to make sure that the machine is operating correctly.
To print a demo page
In ready mode, press and hold the Cancel (
release. (CLP-325W(K)/CLP-326W only)
Also, you can use the Demo page (
page. This button is supported on CLP-320N(K)/CLP-321N only.
Supplied software
After you have set up your machine and connected it to your computer, you
must install the printer software. If you are a Windows or Macintosh OS
user, install the software from the supplied CD. If you are a Linux OS user,
download the software from the Samsung website
(www.samsung.com/printer) and install.
Machine software is occasionally updated for reasons like the release
of new operating system and etc. If needed, download the latest
version from the Samsung website. (www.samsung.com/printer)
Getting started_ 28
2mm
(0.08 in)
) button for 2 seconds, then
) button for printing a demo

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents