Page 1
Diagonal cutters Tape Shop towel Blanket The following tools are available through the Acura Tool and Equipment Program. On the iN, click on Service > Service Bay > Tool and Equipment Program, then enter the number under “Search.” Or, call 888-424-6857.
INSTALLATION Open the glove box, and remove the passenger’s dashboard trim panel. Client Information: The information in this installation PASSENGER’S instruction is intended for use only by skilled DASHBOARD TRIM technicians who have the proper tools, equipment, and PANEL training to correctly and safely add equipment to your vehicle.
Remove the climate control unit, and disconnect the Remove the two bolts. Pull out the audio unit connector. assembly and disconnect the connectors. Remove the harness clips and remove the audio unit. CONNECTORS CLIMATE CONTROL NOTE: There is a lever lock on audio unit connectors. UNIT CLIPS (9) SCREW...
Page 4
Lower the tilt lever. Pull and lower the steering 10. Reconnect the negative battery cable. Then, turn the wheel. ignition to ON. Turn the steering wheel 90° counterclockwise. Using a plastic trim tool, release the retaining tab. STEERING WHEEL 2 CLIPS UPPER COLUMN COVER...
Page 5
13. Remove the dashboard meter visor, and disconnect 15. Remove the GPS antenna and put it aside, it will be the VSA OFF switch connector. reused later. DASHBOARD CLIPS (5) GPS ANTENNA GPS ANTENNA SCREW METER VISOR HARNESS 9.4 N . m (6.5 lb-ft) VSA OFF SWITCH CLIPS (5) 16.
Page 6
18. Using the 6 mm screws, secure the bidirectional 21. Install the GPS antenna and plug in the connector. antenna to the antenna bracket. GPS ANTENNA GPS ANTENNA HARNESS 6 mm SCREW ANTENNA BRACKET BIDIRECTIONAL ANTENNA 9.4 N . m (6.5 lb-ft) 19.
ENGINE REMOTE START SYSTEM REGISTRATION NOTE: The PCM code will be required for this procedure. Connect the HDS to the data link connector. From the HOME menu, select Immobilizer Set Up Tool. From the Registration Menu, select KEYLESS ACCESS Remotes, then select 2-WAY KEYLESS SETUP.