Zenith XBV342 Installation And Operating Manual page 36

Troubleshooting (Continued)
Symptom
Some channels are
skipped over when
using CH/TRK (v/V)
Picture and sound of
broadcasting channel
are weak or missing.
Camcorder image is not
shown.
Camcorder image via
A/V input to DVD+VCR
is not shown on TV
screen.
Timer recording is not
possible.
indicator appears
after DVD+VCR is turned
off.
Stereo Audio Record
and/or Playback is not
present.
Moisture condensation can occur:
• When the DVD+VCR is moved from a cold place to a
warm place.
• Under extremely humid conditions.
36
Cause
Those channels were deleted with the
CH. ADD/DEL option.
Antenna or cables are loose.
Wrong TUNING BAND option is being
used.
Camcorder is off.
DVD+VCR SOURCE SELECT is not set
to LINE1 or LINE2.
Clock in DVD+VCR is not set to correct
time.
Timer has been programmed
incorrectly.
indicator does not appear after pro-
gramming timer.
DVD+VCR is in Timer Recording mode.
TV is not Stereo-compatible.
Broadcast program is not in stereo for-
mat.
DVD+VCR A/V Out jacks are not con-
nected to TV A/V In jacks.
DVD+VCR Audio/Video Out is not
selected for viewing at the TV.
DVD+VCR BROADCAST TYPE mode is
set to SAP or MONO.
Moisture Condensation
Use CH. ADD/DEL. to restore channels.
See "Channel Selection" on page 16.
Tighten connections or replace cable.
Try all TUNING BAND options. See
"Channel Selection" on page 16 for
details.
Turn camcorder on and operate
properly.
Press INPUT to select LINE input
channel (LINE1 or LINE2).
Set clock to correct time. See "Setting
the Clock" on page 17.
Reprogram Timer. See "Timer
Recording" on pages 23 and 24.
Reprogram Timer.
This is the normal indication that the
DVD+VCR is in TIMER mode.
No action is possible.
No action is possible.
Make A/V connections. Stereo is
available only via A/V output from
DVD+VCR.
Select AUX or A/V source as TV input.
Set BROADCAST TYPE mode to
STEREO. See "VCR Setup Menu
Options" on page 16.
In locations where moisture condensation may occur:
• Keep the DVD+VCR plugged into an AC power outlet
with POWER On. This will help prevent condensation.
• When condensation has occurred, wait a few hours
for the DVD+VCR to dry before using it.
Correction