American Standard BAYSQRD001AA Installer's Manual

Models: BAYSQRD001AA and BAYSQRD002AA
WARNING:
ALL phases of this installation must comply with NATIONAL, STATE, AND LOCAL CODES
IMPORTANT - This document is customer property and is to remain with this unit. Please return to service information pack upon
completion of work.
DO NOT APPLY WITH THE DUCT SHROUD COVER KITS
Kit Contents
Supply Adaptor - Qty. 1
Return Adaptor - Qty. 1
Gasketing
Inspection
Check carefully for any shipping damage. This must be
reported to and claims made against the transportation
company immediately. Any missing parts should be
reported to your supplier at once and replaced with
authorized parts only.
Install Adaptor Kit
1. Remove the panels covering both the horizontal supply
and return openings on the unit.
2. Attach gasketing to the flanges on both adaptors.
3. Place one of the adaptors over the supply opening.
Align the adaptor so that the left side edge of the
adaptor flange is flush to the side of the mitred corner
post on the cabinet, and the bottom flange of the
adaptor is flush with the bottom of the cabinet. Secure
with sheet metal screws. See Figure 1.
Installer's Guide
Square to Round Adaptor Kit
HAZARDOUS VOLTAGE - DISCONNECT POWER BEFORE SERVICING
18-HE79D1-1
4. For use with small I2 cabinet*****016-36A Models
- Place the other adaptor over the return opening of the
cabinet. Align the adaptor so that there is 1" between
the flanges of the adaptors and that the bottom flange
is flush with the bottom of the cabinet. Secure with
sheet metal screws. See Figure 2.
For use with medium I2 cabinet *****042-060A
Models - Follow instructions above but leave a 4- 1/2"
gap. See Figure 2.
5. Connect field supplied flex duct to the adaptors and
secure with field supplied clamps. See Figure 3 for
dimensional drawings for flexduct sizing.