Contents For the user Safety Information Description of the appliance - Spray arm - Coarse strainer/microfilter - Fine filter - Detergent dispenser - Rinse aid dispenser - Water softener The control panel - How to set the delayed start Adjusting the water softener Programme chart Loading and unloading Using the appliance...
Safety information Before installing and first using the dishwasher, read this instruction booklet carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the dishwasher are thoroughly familiar with its operation and safety features. Save these instructions and make sure they remain with the dishwasher if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and safety.
4. Close the lid and press until it locks again. Do not fill the rinse aid dispenser with liquid detergent. Zanussi recommends the use of Finish dish- washer detergent and Rinse Aid. Water softener (6) This dishwasher is equipped with a water softener for hard water.
The control panel Programme selector Turn the programme selector clockwise or anticlockwise to select the programme and temperature according to the programme chart. Start/Cancel button In addition to starting a programme you can, by pressing this button, adjust the setting of the water softener and cancel a programme in progress.
Adjusting the water softener To prevent limescaling on the dishes and to the interior of the dishwasher, the dishes must be washed with soft water. This dishwasher is equipped with a water softener, where tap- water which is harder than 4 °d (german degree) is softened. Adjust the water softener according to the table below for the water hardness level for your area.
Programme chart Type of Plates and dishes cooking pots • heavily Type of soiled soil: • dried-on food remnants especially egg- white and starch Suitable programme: INTENSIVE 70° C Pre-wash Programme Washing cycle: 2 x rinses Final rinse Drying Consumption figures: 1) Washing time with...
Loading and unloading the dishwasher How to load the dishes The illustration shows the dishwasher loaded with six place settings. Your own dishes are not likely to be identical to this load, but if you follow the advice below we are sure you will be pleased with the results. Always place glasses, cups and bowls upside down.
Using the appliance Starting the programme 1. Scrape or rinse off solid food remnants. 2. Load the dishwasher. (See the basket and loading). 3. Put the correct amount of detergent into the detergent dispenser and close the dispenser lid. 4. Close the door. 5.
Maintenance and cleaning General cleaning Inspect the filters and spray arm nozzle before re-loading the dishwasher and remove any food scraps. Wipe round the rubber gasket at the bottom of the door to remove grease which tends to collect there. Cleaning the filters There are two filters, a coarse one and a fine one which should be cleaned after every wash.
Something Not Working Before calling out an engineer, please check through the details below because some faults can be rectified easily without the need to call out an engineer. If an engineer is called to resolve a problem listed below or to repair a fault caused by incorrect installation or mis-use a charge will be made, even if the appliance is under guarantee.
Customer Care Department For general enquiries concerning your Zanussi Electrolux appliance or for further information on Zanussi Electrolux products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.zanussi.co.uk...
Standard guarantee conditions We, Zanussi Electrolux, undertake that if within 12 months from the date of the purchase this ZANUSSI ELECTROLUX appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •...
Installation instructions Any electrical work required to install this appliance, should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance, should be carried out by a qualified plumber or competent person. Technical specifications Capacity: Dimensions:...
Unpacking Damages If the dishwasher has been damaged during transport, you should immediately notify the company responsible for delivering it. If you discover any damage, faults or that anything is missing, you should notify your retailer immediately. Never leave packaging material in a place where children may play with it.
Installation Water inlet The dishwasher is equipped with safety features which are to prevent the water from going back to the fresh water system. These features are ac- cording to current water technical safety regulations. The dishwasher should be permanently plumbed into a separate cold water supply.
Power supply The dishwasher is supplied with a lead and electrical plug for connection to a 230 V, 13 A earthed wall socket. Before any work is carried out on the dishwasher, it must be isolated from the electric mains supply, for example by removing the plug from the wall socket.
Information for test centres The salt container and rinse aid dispenser shall be filled in accordance with this instruction manual. Before conducting the measurements the dishwasher shall be operated for one or two complete cycles using detergent and a clean load. Test standard: Rated capacity: Loading of basket:...