Yamaha RX-V1400 Owner's Manual page 30

AUTO SETUP
If you selected AUTO in step 6
The RESULT display appears for a few seconds after each
check, then settings of the next item will start. The
RESULT:EXIT display appears after all items are set.
y
You can display each result by pressing u once and pressing i
repeatedly before exiting. Pressing d returns to the
RESULT:EXIT display.
8
To apply the changes, press j / i to select
SET, then press d to exit.
To cancel the auto setup procedure, press j /
i to select CANCEL, then press d to exit.
If you selected STEP in step 6
The RESULT display appears after each check.
8
Press j / i to display RESULT:EXIT, then
press j / i to select:
NEXT Then press d to proceed and check the next item.
EXIT Then press d to exit the auto setup.
RESULT:WIRING
FRONT L;;;;;;;OK
/ : Up/Down
-/+ : Back/Next
RESULT:DISTANCE1
. FRONT L;;;;3.20m
CENTER;;;;;3.30m
FRONT R;;;;2.90m
PRES L;;;;;1.70m
PRES R;;;;;1.50m
/ : Up/Down
-/+ : Back/Next
RESULT:SIZE 1
FRONT L;;;;;;LRG
/ : Up/Down
-/+ : Back/Next
y
• Press u / d repeatedly to move between each display.
• If you are not satisfied with the result or want to manually
adjust each setup parameter, use the manual setup
parameters (see page 49).
Notes
• If you change speakers, speaker positions, or the layout of your
listening environment, perform AUTO SETUP again to re-
calibrate your system.
• In the DISTANCE results, the distance displayed may be longer
than the actual distance depending on the characteristics of your
subwoofer.
• In the EQUALIZING results, different values may be set for the
same band to provide finer adjustments.
26
RESULT:EQUALIZI.
EQ;;;;;FRONT L
63Hz;;;-2.0dB
125Hz;;;-5.0dB
500Hz;;;;;;0dB
630Hz;;;;;;0dB
1.0kHz;;;;;;0dB
3.15kHz;;;+3.0dB
10.0kHz;;;+1.0dB
/ : Up/Down
RESULT:LEVEL 1
. FRONT L;;;+5.0dB
CENTER;;;;-4.5dB
FRONT R;;;+5.5dB
PRES L;;;;-3.0dB
PRES R;;;;;;--dB
/ : Up/Down
-/+ : Back/Next
If you selected RELOAD in step 6
The RESULT:EXIT display appears.
y
You can display each result by pressing u once and pressing
repeatedly before exiting. Pressing d returns to the
RESULT:EXIT
display.
8
Press j / i to select SET, then press d to exit.
i