Advertisement
Quick Links
LAFT
For ULTRA-2
INSTALLATION & OPERATING GUIDE
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601
FAX: (217) 529-6644
To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts
Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at
www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and
manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
44795.0001C 01/16 ©2012 Bunn-O-Matic Corporation
Advertisement
Related Manuals for Bunn LAFT
Summary of Contents for Bunn LAFT
- Page 1 To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
- Page 2 AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND. In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.
-
Page 3: User Notices
INTRODUCTION This equipment supplies a liquid mix to the hoppers on the ULTRA-2 dispenser. It is for indoor use only on a sturdy counter or shelf. USER NOTICES Carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices are to be kept in good condition. - Page 4 12. Plug LAFT platform power cord into proper electrical outlet. 13. Attach a flexible water line and product line to the .25” flare fitting on the back panel of the LAFT. NOTE: A water strainer assembly (BUNN-O-MATIC #23820.1000) should be installed in line prior to the flexible water line.
- Page 5 1. On the Ultra touch pad, set the base machine to the on position. 2. Push the LAFT slightly toward the rear of the machine so that the level probe is not in contact with the LAFT. 3. Confirm the power switch inside the LAFT is in the ON position.
- Page 6 5. Empty any remaining product from the Ultra hopper. 6. Set the LAFT power switch to on and allow the hopper to fill to about the 1.5 gallon mark, then turn the LAFT power switch off. This is the first mark above the “G” on the left front side of the hopper.
-
Page 7: Fault List
FAULT LIST Door Lamp Fault Normal operation - LAFT ready to dispense Two flashes about every 2 seconds ULTRA LAFT probe circuit open Four flashes about every 2 seconds ULTRA refill exceeded 1 minute - Check BIB or Low Pressure - BIB empty... - Page 8 120V : 24V AC TRANSFORMER WHI/YEL WHI/YEL WHI/GRN WHI/BLK WHI/BLU WHI/ORN PRESSURE SWITCH LED Lited Doors DISPENSE VALVE RIBBED BLK SMOOTH BLK 120 VOLTS AC - 2 WIRE SINGLE PHASE, 50/60 HZ 29780.0005B 01/16 © 2011 BUNN-O-MATIC CORPORATION 44795.1 011216...