Sign in today to find solutions:

Forgot your password?

Don't have an account? Sign up

Yamaha yfm 350 Instruction

Yamaha warrior instruction manual.

 
INSTRUCTION SUPPLEMENT FOR 1987-
LATER YAMAHA YFM350 WARRIOR
Removing stock carburetor and cables.
1. Remove seat and gas tank. Make sure fuel
petcock is in "off" position.
2. Remove throttle cable paying close attention
to routing, as the new cable(s) will need too
be routed the same.
3. Remove stock carburetor and stock throttle
housing.
Preparing motor for carburetor install
1. Remove stock manifold from cylinder head.
2. Place supplied o'ring into aluminum flange
as pictured in figure 1.
Figure 1.
3. Install aluminum and rubber flange to motor
using supplied bolts. See Figure 2. The
shorter 25mm bolt will need to be placed in
the bottom hole. IMPORTANT NOTE: Install
the aluminum flange with the o'ring towards
the motor and the thick side up.
Figure 2.
Twist Throttle Instructions
1. Install the throttle cables into the supplied
throttle housing and place onto clean
handlebar end.
2. Route throttle cables through frame as stock
cable was routed.
3. Install the pull cable (long shoulder on cable)
into the 4:00 position and the return cable
end into the 1:00 position of the cable
wheel. Secure cables to cable bracket by
replacing end piece and Phillips screw. See
figure 3.
Figure 3.
Thumb Throttle Instructions

Summary of Contents

  • Page 1

    INSTRUCTION SUPPLEMENT FOR 1987- LATER YAMAHA YFM350 WARRIOR Removing stock carburetor and cables. 1. Remove seat and gas tank. Make sure fuel petcock is in “off” position. 2. Remove throttle cable paying close attention to routing, as the new cable(s) will need too be routed the same.

  • Page 2

    NOTE: Modification of the stock thumb throttle housing will be required in order to achieve wide open throttle. Figures 4 and 5 will show the mods. Figure 4. Mod number one is to remove material on the outside throttle stop that limits the thumb lever travel.

  • Page 3

    6. Adjust throttle cable to take up the slack. Note: When throttle cables are properly adjusted, there should be approx. 1/8” of free play in the throttle. 7. After throttle cables have been adjusted the handle bars should be rotated from full right stop to full left stop while opening and closing throttle to ensure smooth operation.

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: