Bose L1 Model II Owner's Guide Page 22

Bose l1tm model ii system with tonematchtm port owner's guide.

Download Manual (32 pages, 3.74 Mb) Add to your account Write a comment Upload Manual

YSTEM

ETUP

Adding a PackLite

Figure 10

Connecting the A1

amplifier to the power

stand

power amplifier model A1 (optional)

Using a PackLite

power amplifier model A1 allows you to add one or two additional B1 mod-

ules to your system. Refer to the A1 owner's guide for detailed operating instructions.

1. Make sure the A1 amplifier power switch is OFF.

2. Plug one end of the supplied ¼" TRS cable into the Bass - Line Out connector on the

power stand. Plug the other end into the INPUT connector on the A1 amplifier.

3. Connect a B1 bass module cable from the OUTPUT connector on the A1 to a B1 bass

module. If desired, connect a second B1 to the first B1.

4. Plug one end of the AC power cord into the A1 amplifier and plug the other end into an

AC (mains) outlet.

5. Switch the A1 power switch to ON (I).

Power stand

Bass - Line Out

CAUTION: DO NOT stack more than four

B1 modules in a column.

PackLite

power

amplifier

Additional B1

bass modules

Next page -> <- Previous page

Comments to this Manuals