Installation And Setup Overview; Choosing A Connection Method - Xerox COLORQUBE 8570 User Manual

Installation and Setup

Installation and Setup Overview

This section includes:
•

Choosing a Connection Method

• Connecting to a Network
• Connecting Directly Using USB
Before you can use your printer, you must:
1. Make sure the printer is connected correctly and turned on.
2. Install software drivers and utilities. The software installation procedure depends on your
connection type (network or USB).
3. Configure the software.
Choosing a Connection Method
You can connect to your printer over a network using an Ethernet cable, or directly using a USB cable.
Hardware and cabling requirements vary for the different connection methods. Routers, network hubs,
network switches, modems, Ethernet and USB cables are not included with your printer and must be
purchased separately.
Printing the Connection Setup Page
Your printer comes with a Connection Setup information page, which includes illustrations, to help you
with setup. The Connection Setup page is set to print the first time the printer is turned on if there is
paper in one of the trays. If you need to print the page again, use the following instructions.
To print the Connection Setup page:
1. Plug in the printer, turn it on, then let it warm up.
2. On the printer control panel, select Printer Setup and then press the OK button.
3. Select Connection Setup > OK.
Select Connection Setup Page > OK.
4.
Note: For more connection information and illustrations, refer to the Installation Guide that came
packaged with your printer.
30 ColorQube 8570/8870 Color Printer
User Guide
on page 30
on page 31
on page 31