Xerox WorkCentre PE16 User Manual page 15

Replacing the Fitted Plug (for UK Only)
I
MPORTANT
The mains lead for this machine is fitted with a standard (BS 1363) 13 amp plug and
has a 13 amp fuse. When you change or examine the fuse, you must re-fit the correct
13 amp fuse. You then need to replace the fuse cover. If you have lost the fuse cover,
do not use the plug until you have another fuse cover.
Please contact the people from you purchased the machine.
The 13 amp plug is the most widely used type in the UK and should be suitable.
However, some buildings (mainly old ones) do not have normal 13 amp plug sockets.
You need to buy a suitable plug adaptor. Do not remove the moulded plug.
W
ARNING
If you cut off the moulded plug, get rid of it straight away.
You cannot rewire the plug and you may receive an electric shock if you plug
it into a socket.
I
MPORTANT WARNING
The wires in the mains lead have the following colour code:
• Green and Yellow:
• Blue:
• Brown:
If the wires in the mains lead do not match the colours marked in your plug, do the
following:
You must connect the green and yellow wire to the pin marked by the letter "E" or by
the safety `Earth symbol' or coloured green and yellow or green.
You must connect the blue wire to the pin which is marked with the letter "N" or
coloured black.
You must connect the brown wire to the pin which is marked with the letter "L" or
coloured red.
You must have a 13 amp fuse in the plug, adaptor, or at the distribution board.
xiv
: You must earth this machine.
Earth
Neutral
Live