Xerox WorkCentre PE16 User Manual page 133

Condition
Message appears on your computer
screen:
• "Device can't be set to the H/W
mode you want."
• "Port is being used by another
program."
• "Port is Disabled.
• "Scanner is busy receiving or
printing data. When the current
job is completed, try again."
• "Invalid handle."
• "Scanning has failed."
8.26
T
ROUBLESHOOTING
Suggested solutions
• There may be a copying or printing job in
progress. When the current job is complete,
try the job again.
• The Selected port is currently being used.
Restart your computer and try again.
• The printer cable may be improperly
connected or the power may be off. You
must use a parallel cable that supports
IEEE-1284 bi-directional communications.
• The scanner driver is not installed or an
operating environment is not set up
properly.
• Ensure that port is properly connected
and power is on, Then restart your
computer.
• Check, The USB cable may be improperly
connected or the power may be off.
• Do not use the parallel and the USB
cables at the same time.