Don't Push It - Whistler 800 WATT POWER INVERTER Owner's Manual

INVERTER BASICS

Don't Push It.

Although your Whistler inverter has the capacity to provide
power output (excess current) equal to approximately two
times its rated wattage capacity for a very brief period, it is
designed to operate equipment and appliances with start
up load wattage ratings no higher than its own maximum
continuous wattage rating.
For example, the 800 model has a maximum continuous rat-
ing of 800 watts. Although this model has the capacity to
briefly provide up to 1600 watts of power (that is, excess cur-
rent), it is designed to operate equipment and appliances
with start up load requirements of 800 watts or less.
Consequently, if the start up load rating of your equipment
or appliance is the same or approximately the same as the
maximum continuous rating of the inverter, the inverter will
attempt to start loads above the continuous rating for up to
10 seconds.
To determine whether your inverter will operate a particular
piece of equipment or appliance, run a test. The inverter is
designed to shut down automatically in the event of a
power overload. Testing appliances and equipment with
start up load ratings comparable to your inverter wattage
rating will not damage it.
6
INVERTER BASICS
If a piece of equipment or an appliance will not operate, first
confirm that the inverter has been properly connected to
the 12 volt power source (See "Making The Connection"). If
all connections have been properly made, turn the inverter
rocker switch ON (l), OFF (O) and ON (l) again in quick suc-
cession. If this procedure is unsuccessful, it is likely that the
inverter does not have the required start up capacity to
operate the equipment or appliance in question.
Note:
• Most heat generating appliances require start up
loads in excess of 1000 watts and the inverter will not
operate such appliances as coffee makers, irons, hair
dryers or heaters.
7