Lorex ACCP2SATA Instruction Manual

CONTENTS
1. PATA-to-SATA Converter (x1)
2. Fastening Screws (x 2)
PATA-TO-SATA CONVERTER
Use the PATA-to-SATA converter to convert your existing PATA DVR to a SATA interface.
Use the PATA-to-SATA Converter is compatible with the following systems:
DVR: LCD DVR:
ACCP2SATA ACCP2SATA-SG19
DHU500R Series D17800 Series
L500 Series SG17LD800 Series
SG19LD800 Series
Using the PATA to SATA Converter
ACCP2SATA
NOTE: If your system uses two hard drives, you will need an additional PATA-to-SATA Converter.
1. Power off your DVR system.
2. Carefully remove the SATA hard drive and mounting bracket
according the steps outlined in your system's instruction
manual.
3. Attach the PATA to SATA Converter to the new SATA hard drive
(not included) (see figure 1.0).
NOTE: The PATA to SATA Converter can only connect one way.
Make sure the converter is firmly connected to the SATA hard
drive.
4. Insert the SATA HDD with converter into the mounting bracket.
PATA-TO-SATA
CONVERTER
Instruction Manual
FASTENING
SCREWS
(Included with ACCP2SATA-SG19 only)
English Version 1.0
MOUNTING PLATE FOR LCD DVR
Figure 1.0 Attach the PATA-to-SATA
converter to the new SATA HDD
Copyright © 2009 Lorex Technology Inc.