3M 2470 Installation Instructions Manual page 17

Performance series
Hide thumbs Also See for 2470:
Table of Contents

Advertisement

Performance Series
07:VOX Enable
{Off}
08:
VOX Sensitive
{15}
09:Talk Vol{10}
S=01 PUMP
# 01
10:Music Volume
{08}
11:Priority{Off}
S=xy: User Name
12:Auto Standby
{On)
13:Standby Mode
{Silence}
14:Selector Name
S=xy: User Name
15:Station Name
S=xy: User Name
A value (On, Off). Default = Off. Enables the VOX (Voice Operated
Transmission) feature.
A number (1 to 15 inclusive). Default = 15 (most sensitive). Adjust this value
to accommodate the ambient noise level at the Station Selector location. Use a
lower value for a higher noise environment.
A number (1 to 15 inclusive). Default = 08. The outbound voice volume is
adjusted for all Call Stations simultaneously. Each Call Station can be
individually selected. An assistant can be sent out to each Call Station. When
the Talk key is momentarily pressed, it remains in the Talk state until pressed
again, and then it remains in the Listen state. This allows the installer to
communicate with the assistant over the intercom in setting the proper volume
level.
This value must be adjusted after adjusting Talk volume!
A number (0 to 15 inclusive). Default = 08. With a value of {00} music will
be muted.
A value (Off, 1 to 24 inclusive). Default = Off. The Call Station selected here
has top propriety call in over all other Call Station requests.
A value (On or Off). Default = On. Enables the 90-second station connection
time out. If the Talk key is not pressed within 90 seconds, the Station Selector
returns to the Standby mode.
A value (Silence or All Listen). Default = Silence. "Silence" selects no
inbound volume during Standby mode. "All Listen" allows all Call Stations to
be monitored during Standby mode.
Assignment of Station Selector names (Station Selector numbers 71 through
85 correspond to Station Selector ID numbers 1 through 15) where xy
indicates Station Selector number. Default = SELECTOR xy where xy =
Station Selector number (see "Keypad Function Definitions for Text Entry").
Assignment of Call Station names (01 through Max Stations) where xy
indicates station number. Default = PUMP number xy where xy = station
number (see "Keypad Function Definitions for Text Entry").
Programming the System
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2475

Table of Contents