Whirlpool GGE350LW Dimensions And Installation Information

®
PRODUCT MODEL NUMBERS
GGE350LW
Electrical: To properly install your range, you must determine the type
of electrical connection you will be using and follow the instructions
provided for it here.
Range must be connected to the proper electrical voltage and frequency
as specified on the model/serial number rating label. The model/serial
number rating label is located on the bottom right front of the toe kick
plate. Refer to the figures in the "Product Dimensions" section of the
"Location Requirements" section.
This range is manufactured with the neutral terminal connected to the
cabinet. Use a 3-wire, UL listed, 40- or 50-amp power supply cord
(pigtail) (see following Range Rating chart). If local codes do not permit
ground through the neutral, use a 4-wire power supply cord rated at
250 volts, 40 or 50 amps and investigated for use with ranges.
Range Rating*
120/240 Volts 120/208 Volts
8.8 - 16.5 KW 7.8 - 12.5 KW
16.6 - 22.5 KW 12.6 - 18.5 KW
*The NEC calculated load is less than the total connected load listed on
the model/serial rating label.
**If connecting to a 50-amp circuit, use a 50-amp rated cord with
kit. For 50-amp rated cord kits, use kits that specify use with a
nominal 1 " (34.9 mm) diameter connection opening.
A circuit breaker is recommended.
CABINET OPENING DIMENSIONS
Cabinet opening dimensions shown are for 25"
(64.0 cm) countertop depth, 24" (61.0 cm) base
cabinet depth and 36" (91.4 cm) countertop height.
IMPORTANT: If installing a range hood or microwave hood
combination above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
A freestanding range may be installed next to combustible
walls with zero clearance.
*NOTE: 24" (61.0 cm) minimum when bottom of wood or
metal cabinet is covered by not less than 1⁄4" (0.64 cm)
flame retardant millboard covered with not less than No. 28
MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024"
(0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the
cooking platform and the bottom of an uncovered wood or
metal cabinet.
Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Freestanding Electric Range with Double Ovens
Specified Rating of
Power Supply Cord Kit
and Circuit Protection
Amps
40 or 50**
50
PRODUCT DIMENSIONS
A
E*
A. 46 " (119.9 cm)
B. Model/serial number rating
label (located on bottom right
front of the toe kick plate)
*Excludes handle. Dimension given is from wall to front of oven
door and will vary based on electric outlet receptacle installation.
F
A. 13" (33 cm) upper cabinet
depth
B. 30" (76.2 cm) min. opening
width
C. For minimum clearance to the
top of the cooktop, see NOTE.
D. 30" (76.2 cm) min. opening
width
E. Cabinet door or hinge should
not extend into cutout.
*Nothing located in shaded areas can extend more than 1½"
(3.8 cm) from wall or range will not slide all the way back.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
D
C. 35 " (91.4 cm)
D. 29 " (75.9 cm)
E. 26 27¼" (66.8 - 69.2 cm)*
A
C
B
D
G
E
H
F. 3-wire shaded area -
7" (17.8 cm) min. from left side
cabinet, 5¾" (14.6 cm) max.
from floor, 6" (15.2 cm) max.
width*
G. 4-wire shaded area -
10" (25.4 cm) min. from right
side cabinet, 5¾" (14.6 cm)
max. from floor, 6" (15.2 cm)
max. width*
H. 1½" (3.8 cm) min. from floor if
using a flush mount outlet.
C
B
Ref. W10270322A
8/28/09