Installation; Television Location; Optional Cable Connections; Ac Power Supply Cord - Panasonic PT-47WX49 Operating Instructions Manual

I
NSTALLATION

Installation

Television Location

This unit can be used as an entertainment center. Consult your dealer for available options.
r
r
r
r

Optional Cable Connections

Shielded audio and video cables should be used between components. For best results:
r
r
r

AC Power Supply Cord

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE A PLUG WITH A
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR
PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE
THEY EXIT FROM THE APPARATUS.
Cable / Antenna Connection
For proper reception, either a cable or antenna connection is required.
Cable Connection
Connect the cable supplied by your local cable company to ANT1
connection on back of television. Select cable mode and ANT1 in SET UP
menu under Prog Chan (Program Channels).
Note:
Antenna Connections
6
Avoid excessive sunlight or bright lights, including reflections.
Keep away from excessive heat or moisture. Inadequate ventilation may cause internal
component failure.
Fluorescent lighting may reduce remote control transmitting range.
Keep away from magnetic equipment, including motors, fans and external speakers.
Use 75-ohm coaxial shielded cables.
Use appropriate input and output connectors, that match your component connectors.
Avoid long cables to minimize interference.
A cable converter box may be required for proper reception.
Check with your local cable company for compatibility
requirements.
• For proper reception of VHF/UHF channels, an external antenna is required. For
best reception an outdoor antenna is recommended.
•
Connect home antenna to ANT1 connection on back of
television. Select TV mode and ANT1 in the SET UP menu
under Prog Chan.
Cable Preset
Cable Mode is preset at the factory.
Antenna users must change to TV Mode and
ANT 1 in the Set Up menu.
Polarized plug
Incoming Cable from
Cable Company
75 Ohm VHF/UHF
on back of PTV
Incoming Cable from
Home Antenna