Undercounter Start-Up Guide; Using Your New Dishwasher; Stopping Your Dishwasher - Whirlpool 800 Series Use And Care Manual
Whirlpool dishwasher use & care guide series
Hide thumbs
Also See for 800 Series:
- Use & care manual (16 pages) ,
- Use and care manual (68 pages) ,
- Use & care manual (40 pages)
Table of Contents
Advertisement
Available languages
Available languages
UNDERCOUNTER
START-UP GUIDE
Before using your dishwasher, remove all packaging materials.
Read this entire Use and Care Guide. You will find important
safety information and useful operating tips.
Using Your New Dishwasher
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector
in terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
1. Scrape large food soil and hard items (toothpicks or bones)
from dishes.
2. Properly load the dishwasher. (See “Dishwasher Loading.”)
Make sure nothing prevents the spray arm(s) from spinning
freely.
3. Add detergent and check the rinse aid dispenser. Add rinse
aid if needed. (See “Dishwasher Use.”)
4. Push door firmly closed. The door latches automatically. Run
hot water at the sink nearest your dishwasher until the water
is hot. (See “Dishwasher Efficiency Tips.”) Turn off water.
5. Select a drying option.
NOTE: Use Air Dry for the Rinse Only cycle.
6. For Series 840, 850 and 890: Press the desired cycle and
option selections. (See “Dishwasher Use.”) Turn the Cycle
Control knob to the desired cycle to start.
Stopping Your Dishwasher
You can stop your dishwasher anytime during a cycle.
1. Open the door slightly.
2. Wait for the spraying action to stop. Then open the door all
the way, if needed.
3. Close the door to continue the cycle.
OR
1. Turn the Cycle Control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2. Open the door.
3. Turn the Cycle Control knob to OFF.
Page 7
Hide quick links:
Advertisement
Table of Contents
