E. The device has been dropped, or the enclosure damaged. DO NOT ATTEMPT SERVICING OF THIS UNIT YOURSELF. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. | ADCOM GFA-6006/02 Owner’s Manual POUR PREVENIR LES CHOCS ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE AVEC UN PROLONGATEUR, UNE PRISE CE COURANT OU UNE AUTRE SORTIE CE COURANT, SAUF SI LES LAMES PEUVENT ETRE INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE A DECOUVERT.
Unpacking the Amplifier Before your new ADCOM amplifier left our factory, it was carefully inspected for physical imperfections and tested for all electrical parameters as a routine part of ADCOM’s systematic quality control. This, along with full operational and mechanical testing, should ensure a product flawless in both appearance and performance.
Description of Unit Congratulations on your decision to purchase the GFA-6002 or GFA-6006 custom installation power amplifier. The GFA-6002 and GFA-6006 have been designed to be musically accurate in a configuration specifically designed to integrate with any home audio pre-amplifier. You have made a wise choice that will reward you for years to come with exceptionally accurate and musical sound reproduction.
Not only will heat generated by the amplifier affect the performance of equipment stacked on top of the GFA-6002/6006, but the free flow of air through the ventilating slots in the amplifier may be partially obstructed. If you observe these recommendations,...
[ 2 ] Thermal Protection The GFA-6002/6006 are provided with a thermal protection circuit which will shut down the individual amplifiers if its heatsink temperature reaches 85°C.
Bridged Mono Input is to be used. On the GFA-6006, bridged mono inputs are channels 1,3, and 5. On the GFA-6002, bridged mono input is channel 1. For “daisy-chaining” the corresponding outputs for these channels are active. [ 6 ] Input Level Adjustment Each channel has an input level adjustment.
Page 10
| ADCOM GFA-6006/02 Owner’s Manual [ 9 ] 3-30V AC/DC Triggering The GFA-6002 and GFA-6006 are very high power amplifiers and as such must be directly connected to the wall outlet or an appropriate surge protector or AC line conditioner.
VCR). If the hum is no longer present, you must insert a “75Ω ground loop isolator” before reconnect- ing the line. You should check with your ADCOM dealer to obtain one. If the “75Ω ground loop isolator” works only partially or not at all, then please read note 2 to complete the troubleshooting procedure.
The above warranties are subject to the following conditions: (1) You must retain and present your dated invoice or bill of sale to provide proof of original purchase from an ADCOM Authorized Dealer and coverage under the warranty period. (2) You must notify us within ten (10) days after you discover a defective product or part.