Maintenance - Weider Pro 4950 831.14623.0 User Manual

MAINTENANCE

Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts imme-
diately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use
solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the
weight pin into the middle of the weight stack. Slack can be removed from these cables several ways:
See drawing 1. Remove the M10 Nylon
•
Locknut (77) and the M10 x 50mm Bolt (97)
from the Cable Trap (56), the 90mm Pulley (48),
the two Half Guards (55), and the two Pulley
Plates (60). Reattach the Pulley, Cable Trap,
and Half Guards to the next closer hole to the
center of the Pulley Plates. Make sure that the
Cable Trap is oriented to hold the cable in
the groove of the Pulley, that the Half
Guards are oriented as shown, and that the
Cable and Pulley move smoothly.
• See drawing 2. Loosen the M12 Nut (112) on
the Lat Cable (49). Tighten the Cable into the
Weight Tube (not shown) until the slack is
removed from the Cable. Retighten the M12
Nut against the M12 Washer (98).
Do not overtighten the cables. If the cables are overtightened, the top weight will be lifted off the weight
stack. If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and
re-install it. If the cables need to be replaced, see the part ordering information on the back cover of this manual.
1
97
55
56
2
49
34
60
55
77
48
112