Frame Assembly - Weider 9940 User Manual

Frame Assembly

1. Before beginning, make sure that you have read
and understood the information on page 4.
Locate and open the parts bag labeled "FRAME
ASSEMBLY."
See drawing 1a. Press a 2" Square Inner Cap (28)
into each end of the Butterfly Base (4). Press two 2"
Square Inner Caps (28) into the Weight Base (5).
Insert four 5/16" x 2 1/2" Carriage Bolts (92) up
through the indicated holes in the Butterfly Base (4).
Insert a 3/8" x 3 1/2" Carriage Bolt (95) up through
the hole at the end of the Butterfly Base. Note: If the
Bolts fall out, secure them by putting a small
piece of tape over the head of each Bolt. Place the
Butterfly Base flat on the floor.
See drawing 1b. Attach the Weight Base (5) to the
Butterfly Base (4) with two 5/16" x 2 3/4" Bolts (89), a
Support Plate (93) with 3 1/2" center holes, and two
5/16" Nylon Locknuts (64). Do not tighten the Nylon
Locknuts yet.
Note: There are three kinds of support plates. The
main difference between them is the distance
between the holes. When you need a support
plate, find the type with holes that will fit over the
bolts you are using.
2. See drawing 2a. Press a 2" Square Inner Cap (28)
into the end of the Press Base (6).
Attach a 3 1/2" Pulley (24) to each of the brackets on
the Weight Base (5) with a 3/8" x 1 3/4" Bolt (57) and
a 3/8" Nylon Jamnut (63).
Insert four 5/16" x 2 1/2" Carriage Bolts (92) up
through the indicated holes in the Press Base (6).
Insert a 3/8" x 2 1/2" Carriage Bolt (101) and a 3/8 x
4" Carriage Bolt (102) up through the indicated holes
at the end of the Press Base (6).
See drawing 2b. Attach the Press Base (6) to the
Weight Base (5) with two 5/16" x 2 3/4" Bolts (89), a
Support Plate with 3 1/2" center holes (93), and two
5/16" Nylon Locknuts (64). Do not tighten the Nylon
Locknuts yet.
1a
4
92
28
1b
89
93
4
2a
5
57
2b
5
64
6
5
28
28
95
92
5
64
64
5
24
63
63
57
6
102
92
101
92
64
93
28
28
89