Cable Assembly - Weider 8530 User Manual

During steps 13 to 25, refer to the CABLE DIA-
GRAM on page 19 of this manual. Identify the
three cables by their lengths, and note the
positions of the cable traps. IMPORTANT: Do
not overtighten the bolts and nuts securing
the pulleys. The pulleys must turn freely.
13. Locate the Medium Cable (58). Route the
Medium Cable around the indicated 3 1/2"
Pulley (15) attached to the Top Frame (55).
Be sure that the ball is on the indicated
side of the Pulley and that the Cable is
between the Pulley and the hook. Tighten
the 3/8" x 3 3/4" Bolt (88) and the 3/8" Nylon
Locknut (not shown).
14. Wrap the Medium Cable (58) around a "V"-
Pulley (50). Attach the "V"-Pulley and a Long
Cable Trap (31) to the indicated bracket on
the Front Upright (42) with a 3/8" x 2 1/2" Bolt
(86) and a 3/8" Nylon Locknut (21). Be sure
that the Long Cable Trap is positioned to
hold the Cable in place.
Route the Medium Cable (58) around the "V"-
Pulley (50) on the Left Arm (47). Be sure that
the Cable is in the groove of the Pulley and
that the Long Cable Trap (31) holds the
Cable in place. Tighten the 3/8" x 2 1/2" Bolt
(86) and the 3/8" Nylon Locknut (not shown).
15. Route the Medium Cable (58) around the "V"-
Pulley (50) on the Right Arm (48). Be sure
that the Cable is in the groove of the "V"-
Pulley and that the Long Cable Trap (31) is
positioned to hold the Cable in place.
Tighten the 3/8" x 2 1/2" Bolt (86) and the 3/8"
Nylon Locknut (not shown).
Route the Medium Cable (58) around the
3 1/2" Pulley (15) attached to the Pulley
Bracket (20). Be sure that the Cable is in
the groove of the Pulley and that the Cable
Trap (66) holds the Cable in place. Tighten
the 3/8" Nylon Locknut (21) and the 3/8" x 2"
Bolt (not shown). Tighten the 5/16" x 5" Bolt
(68) and the 5/16" Nylon Locknut (not shown).
Be sure that the Pulley Bracket swivels freely.
16. See the inset drawing. Attach a 3 1/2" Pulley
(15) and a Cable Trap (66) to the upper hole
in the Long "U"-Bracket (57) with a 3/8" x 2"
Bolt (12) and a 3/8" Nylon Locknut (21). Be
sure that the Cable Trap is inside the Long
"U"-Bracket. (Note: This may come pre-
assembled.)
Route the Medium Cable (58) through the
3 1/2" Pulley (15) and Long "U"-Bracket (57)
shown in the inset drawing. Be sure that the
Cable is in the groove of the Pulley and
that the Cable and Pulley move smoothly.
13
55
15
Ball
Hook
14
31
86
50
47
15
68
31
20
66
21
58
16
15
58
15
66
12
21
57
10
58
88
86
58
31
50
Bracket
21
42
86
50
48
15
58
57