Siemens 986-88301A Installation Instructions

Andover Infinet Driver
These installation instructions only cover the
connection of the Andover Infinet Driver to the
Andover system. For hardware installation of the
Modular Equipment Controller, see document number
565-570. For hardware installation of the Power
Open Processor, see document number 565-571.
Product Description
The Andover Infinet Driver enables communication
®
between the APOGEE
Andover network.
Product Numbers
986-88301A
986-88301B
986-88301C
986-88301D
986-88301E
986-88301F
986-88301G
986-88301H
Item Number: 565-709, Rev. AA
Automation System and the
Andover Infinet Driver, Open
Processor with RS-485 ALN
Andover Infinet Driver, Open
Processor with Ethernet ALN
Andover Infinet Driver, MEC
with RS-485 ALN, 8DI, 8DO,
8AI, 8AO, point expansion
support, HOA-ready
Andover Infinet Driver, MEC
with RS-485 ALN, 8DI, 8DO,
8AI, 8AO, point expansion
support, with HOA
Andover Infinet Driver, MEC
with RS-485 ALN, 8DI, 8DO,
8AI, 8AO, point expansion
support, modem, HOA-ready
Andover Infinet Driver, MEC
with RS-485 ALN, 8DI, 8DO,
8AI, 8AO, point expansion
support, modem, with HOA
Andover Infinet Driver, MEC
with Ethernet ALN, 8DI, 8DO,
8AI, 8AO, point expansion
support, HOA-ready
Andover Infinet Driver, MEC
with Ethernet ALN, 8DI, 8DO,
8AI, 8AO, point expansion
support, with HOA
Installation Instructions
Warning/Caution Notations
WARNING:
Personal injury/loss of life may occur if you
do not follow the procedures as specified.
CAUTION:
Equipment damage or loss of data may
occur if you do not follow the procedures
as specified.
Expected Installation Times
30 minutes.
Required Tools and Materials
• Flat-blade screwdriver (1/8-inch blade width).
• Wire strippers.
• Cabling and connectors. See the Connecting
the Andover Infinet Driver to the Andover
Network section.
CAUTION:
Always wear an electro-static discharge
wrist strap and discharge accumulated
static before touching field panel
components.
Prerequisites
• Driver hardware is installed according to its
respective installation instructions.
• FLN Termination blocks installed, if any.
Depending on the type of installation, other
prerequisites may have to be completed.
Document No. 565-709
December 1, 2006
Page 1 of 2