Page 1
R2200/2200 HRC A SSE M BLY I N ST R UCT I O N S To avoid possible damage to this Fitness Cycle, please follow these assembly instructions. Carefully remove all its parts from the box, lay them out and review the parts list.
VISION FITNESS R2200 Parts Description Part # Description Front Wheel Parts #148 Front Foot Wheel Axle #149 Front Transport Wheels #150 Inside Wheel Washers #185 Outside Wheel Washers #182 Wheel Attachment Bolts Rear Rail Support Bars #106 Rear Foot Assembly...
Assembly NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt. Step 1 • Front Wheel Assembly 1: Slide the Front Foot Axle (148) through the Front Foot Nylon Sleeves (147). 2: Place the Inside Wheel Washers (150) on the Front Foot Axle (148).
Step 3 • Seat Assembly 1: Secure the Seat Mount Handlebars (110) to the Seat Frame (115) with four Seat Mount Handlebar Bolts (182). 2: When mounting the Seat Cushion Bottom (136), you have two sets of holes to choose from. Using the rear set of holes is recommended for most people.
Assembly Step 5 • Pedals 1: Identify the left and right Pedals (152) and the left and right Pedal Straps (199). Attach the correct straps to each pedal, then thread each Pedal into the correct left and right crank arms and tighten. NOTE: It is very important to FULLY TIGHTEN each pedal.
Once these electrodes are moistened, center the transmitter just below the breast or pectoral muscles with the Vision Fitness logo centered on the chest and facing out. Adjust the length of the elastic belt so that the transmitter presses firmly against your skin, but not so tight as to be uncomfortable.
Page 8
621-D East Lake Street P.O. Box 280 Lake Mills, WI 53551 (920) 648-4090...