Viper 160XVL Owner's Manual
  1. Manuals
  2. Brands
  3. Viper Manuals
  4. Remote Starter
  5. 160XVL
  6. Owner's manual

Viper 160XVL Owner's Manual

Remote start keyless entry system
Hide thumbs Also See for 160XVL:
Table of Contents

Advertisement

Quick Links

See also: Installation Manual
Model 160XVL
Owner's Guide

Advertisement

Table of Contents
loading

Related Manuals for Viper 160XVL

Summary of Contents for Viper 160XVL

  • Page 1 Model 160XVL Owner's Guide...

  • Page 2: Limited Lifetime Consumer Warranty

    Limited Lifetime Consumer Warranty Directed Electronics promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed Electronics unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following con- ditions are met: the unit was professionally installed and serviced by an authorized Directed Electronics dealer;...
  • Page 3 HEREBY EXPRESSLY DISCLAIMS ANY LIABILITY WHATSOEVER, INCLUDING WITHOUT LIMITATION, LIABILITY FOR THEFT, DAMAGE AND/OR VANDALISM. THIS WARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOVAL OR REIN- STALLATION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED ELECTRONICS OR ITS SUB- SIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA.

  • Page 4: Table Of Contents

    Table of Contents Limited Lifetime Consumer Warranty ......i Standard Configuration ........2 What is Included .

  • Page 5: Standard Configuration

    Standard Configuration controls the Arm/Panic ON/Panic OFF function. controls the Disarm function. controls Silent Mode™and an Auxiliary Output. controls Remote Start. controls Timer mode. controls Turbo/Short Run. controls Channel 4 output. controls Rear Defroster. 2006 Directed Electronics—all rights reserved ©...

  • Page 6: What Is Included

    What is Included ■ The control module ■ A Venom SST receiver/antenna ■ Two four-button transmitters ■ The blue status LED indicator light ■ A push-button Valet button ■ Your warranty registration ■ A shut-down toggle switch Important Information Congratulations on the purchase of your remote start keyless entry system.

  • Page 7: System Maintenance

    System Maintenance The system requires no specific maintenance. Your remote is powered by two small, lightweight 3-volt lithium batteries that will last approximately one year under normal use. When the battery begins to weaken, operating range will be reduced and the LED on the remote will dim.

  • Page 8: Caution

    and its antenna must maintain a separation distance of 20 cm or more from the person’s body, except for the hand and wrists, to satisfy RF exposure compliance. This device is designed to be used in a person’s hands and its operating configurations do not support normal trans- missions while it is carried in pockets or holsters next to a persons’...

  • Page 9: Transmitter Functions

    Transmitter Functions The receiver uses a computer-based learn routine to learn the transmitter buttons. This makes it possible to assign any specific transmitter button, or combination of buttons, to any receiver function. The transmitter initially comes programmed with the Standard Configuration, but may also be customized by an autho- rized dealer.

  • Page 10: Using Your System

    The remote start function of your system is controlled by pressing this button twice within 3 seconds. Buttons An optional auxiliary convenience or expansion function that you have added to your system can be activated by pressing these but- tons simultaneously. The auxiliary output controls __________________________.
  • Page 11 When parking in an enclosed or partially enclosed area or when having the vehicle serviced, the remote start system must be disabled using the installed toggle switch. It is the user's sole responsibility to properly handle and keep out of reach from children all remote control transmitters to assure that the system does not unintentionally remote start the vehicle.

  • Page 12: Arming

    module by performing the Safety Check outlined in the prod- uct installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The remote start module must be removed or the installer must properly reinstall the remote start system so that the vehicle does not start in gear.

  • Page 13: Disarming

    Starter Kill automatically (called Passive Mode). If the system has been programmed for Passive Mode, the Failsafe automatically activate 30 seconds after the ignition has been turned off. After the ignition has been turned off, the status LED will flash rapidly to indicate that the system is in Passive Mode. If Passive Mode has been programmed on, then it is also possible to program the system for Passive Locking.

  • Page 14: Disabling The Starter Kill Without A Transmitter

    Disabling the Starter Kill Without a Transmitter If your remote transmitter is lost or damaged, you can manually override the starter kill. To do this, you must have the vehicle's ignition key and know where the Valet button is located. Be sure to check with the installer for the location of the Valet button.

  • Page 15: Panic Mode

    To enter or exit Valet Mode: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the Valet button within 10 seconds. The status LED will light steadily if you are entering Valet Mode and will turn off if you are exiting Valet Mode. Panic Mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter.

  • Page 16: Remote Start

    Remote Start This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehi- cle with the climate control system. If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must be set to the desired level prior to remote starting the vehicle.

  • Page 17: Rear Defogger

    When you are ready to drive the vehicle: 1. Insert the ignition key and turn it to the ON (not the START) position. Press the brake pedal. NOTE: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.

  • Page 18: Valet Take-Over

    To turn the rear defogger output ON: Simultaneously press & release the on the remote control. The lights will flash 3 times. The rear defogger output will once again activate when the vehicle is remote started. NOTE: If the remote start is on the lights will turn off then flash 3-times before returning to their normal output and the defogger output will activate as programmed.

  • Page 19: Short-Run/Turbo

    Short-Run/Turbo Short-run turbo mode keeps the engine running after arriving at you destination for a programmable period of 1, 3 ,5 or 10 min- utes. This allows the system’s timer to conveniently cool down the turbo after you have left the vehicle. To activate: Park the vehicle and set parking brake.
  • Page 20 The vehicle will confirm with 4 parking light flashes. A 1-second delay will start. The system will start the car and will run for the specified duration, unless shut down by the remote start button . If shut down with the remote start button will remain in timer mode.

  • Page 21: Starter Anti-Grind Circuitry

    Starter Anti-Grind Circuitry Whenever the vehicle is remote started, advanced anti-grind cir- cuitry prevents the starter from engaging, even if the key is turned to the start position. This prevents damage to the starter motor if the key is turned to the start position during remote start operation. NOTE: Anti-grind circuitry only works when the remote start system is operating the motor and the Failsafe Disabling the Remote Start System...

  • Page 22: Rapid Resume Logic

    Rapid Resume Logic This Directed Electronics system will store its current state to non- volatile memory. If power is lost and then reconnected the system will recall the stored state from memory. This means if the unit is in Valet Mode and the battery is disconnected for any reason, such as servicing the car, when the battery is reconnected the unit will still be in Valet Mode.

  • Page 23: Ncomfort Closure Is A Programming Option Which Closes The Vehicle's Windows After Remote Locking

    ■ Comfort closure is a programming option which closes the vehicle’s windows after remote locking. ■ Parking lights flashing or constant. Your system can be pro- grammed to either flash or to turn on the parking lights con- stantly during the entire remote start operation. ■...

  • Page 24: Glossary Of Terms

    Glossary of Terms Control Unit: The “brain” of your system. Usually hidden under- neath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all system functions. Failsafe ® Starter Kill: An automatic switch controlled by your sys- tem which prevents the vehicle’s starter from cranking whenever the system is armed.

  • Page 25: Convenience Expansions

    Convenience Expansions Listed below are some of the many expansion options available for use with your system. Some options may require additional parts and/or labor. Please consult with your dealer for a complete list of options available for use with this system. Domelight Supervision: The domelight will illuminate for 30 seconds each time the system is disarmed using the transmitter.
  • Page 26 Power Window Control: Power window control is provided with Directed Electronics 529T or 530T systems. The 529T system will roll up two windows automatically when the system is armed, or roll two windows down by using the transmitter. The 530T will roll two windows both up and down.

  • Page 27: Notes

    Notes 2006 Directed Electronics—all rights reserved ©...

  • Page 28: Quick Reference Guide

    Quick Reference Guide To arm using your remote ■ To arm the system press nected). The LED will begin to flash. The vehicle’s horn (if connected) will honk and the parking lights will flash once to confirm arming. To disarm using your remote ■...
  • Page 29 Valet Takeover ■ Press and release ignition key to the OFF position. Once the vehicle has started, it will run for the pre-programmed period of time (12, 24, or 60 minutes). Rear Window Defogger ■ Press the on or off when remote starting. When a remote start is initiated, the parking lights will flash 2-times if the defogger is set to off, and will flash 3-times if the defogger is set to on.
  • Page 30 The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, Directed Electronics is ISO 9001 registered.

Table of Contents