Lighting (Continuous Pilot) - UTICA BOILERS Gas-fired Boiler Operating Instructions Manual

LIGHTING PROCEDURE FOR BOILER LIGHTING PROCEDURE FOR BOILER LIGHTING PROCEDURE FOR BOILER
LIGHTING PROCEDURE FOR BOILER LIGHTING PROCEDURE FOR BOILER
FOR YOUR SAFETY READ BEFORE LIGHTING FOR YOUR SAFETY READ BEFORE LIGHTING FOR YOUR SAFETY READ BEFORE LIGHTING FOR YOUR SAFETY READ BEFORE LIGHTING FOR YOUR SAFETY READ BEFORE LIGHTING
A. Read the warning at the beginning of the LIGHTING INSTRUCTIONS. (Page 13)
B. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow
these instructions exactly.
C. Before lighting, smell all around the appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air and will settle on the floor. See page 14 for
WHAT TO DO IF YOU SMELL GAS.
D. Use only your hand to push in or turn gas control knob or reset button. Never use tools.
If the knob or reset button will not push in or turn by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may result in a fire or explosion.
E. Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect the appliance and to replace any part of the control system and
any gas control which has been under water.
STOP! STOP!
1. STOP! STOP! Read the safety information at the beginning of these instructions. STOP!
2. Set the thermostat to the lowest setting.
3. Turn off all electric power to the appliance.
4. Remove access panel and burner door.
5. Turn gas control knob clockwise
NOTE #1: Some gas control knobs cannot be turned from "PILOT" to "OFF" unless
knob is pushed in slightly. DO NOT FORCE.
FIGURE 15
6. Wait (5) minutes to clear out any gas. If you then smell gas, STOP! Follow "What To
Do If You Smell Gas", on page 14. If you don't smell gas, go to the next step.
7. Find pilot. Follow metal tube from gas control. Depending on the model of the boiler,
pilot is either mounted on the base or on one of the burner tubes.
8. Turn gas control knob counterclockwise
WITH CONTINUOUS PIL WITH CONTINUOUS PILO O O O O T T T T T WITH CONTINUOUS PIL
WITH CONTINUOUS PIL WITH CONTINUOUS PIL
LIGHTING INSTRUCTIONS FOR LIGHTING INSTRUCTIONS FOR
LIGHTING INSTRUCTIONS FOR LIGHTING INSTRUCTIONS FOR LIGHTING INSTRUCTIONS FOR
CONTINUOUS PILO O O O O T T T T T CONTINUOUS PIL CONTINUOUS PIL
CONTINUOUS PIL CONTINUOUS PIL
DO NOT FORCE. DO NOT FORCE.
DO NOT FORCE. DO NOT FORCE.
to "OFF". See figure's 15 & 16 below.
to "PILOT".
PAGE 15
FIGURE 16