Step 4 Insert Gas Line Through Platform / Attach Shroud Cover; Step 5 Attach Engine To Post - Charmglow 200605 Owner's Manual

Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 4 – Insert Gas Line through Platform/Attach Shroud Cover
Insert Gas Line up through large hole in Platform from underneath
between center and left leg as shown in illustration .
Slide Shroud Cover over Gas Line, then over Platform/Leg assembly
until bottom of Shroud rests on Base .
Step 5 – Attach Engine to Post
Lay Engine Assembly on its side, using carton for support .
Remove and save Control Knob .
Remove and save Engine Access Panel by removing () black
Thumbscrew from bottom of Access Door .
Disconnect wire from Igniter by gently pulling wire from back of box .
Align (4) holes in top of Post with (4) holes in bottom of Engine .
Note: One hole is at a different level than the rest . Make sure that all 4
holes line up properly .
Insert (4) Small Screws enough to hold Engine in place . They will be fully
tightened at the end of Step 7 .
Note: Do not replace Engine Access Panel until Step 3 .
Owner's manual: model 200605 outdoor patio heater 8