Installation Configurations; Mobile Home Installation Requirements - USSC American Harvest 6037 Owner's Manual

INSTALLATION CONFIGURATIONS

Note: Where passage through a wall, or partition of combustible construction is desired, the installation
shall conform to CAN/CSA -B365
The American Harvest Corn/Pellet Stove Model 6037 may be installed as follows:
1) A freestanding unit

MOBILE HOME INSTALLATION REQUIREMENTS

IN ADDITION TO THE STANDARD INSTALLATION INSTRUCTION, THE FOLLOWING
REQUIREMENTS ARE MANDATORY FOR INSTALLATION IN A MOBILE HOME:
1) Stove must be permanently bolted to the floor. Remove the Base Trim and bolt thru the base flange.
2) Stove must have permanent outside air source. (67FAK)
3) Stove must be permanently electrically ground to the steel chassis of the mobile home.
4) All vertical chimney vent must have wall supports.
5) All exhaust systems must have a spark arrestor.
THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL AND CEILING/
Check with your local building official as other codes may apply.
FLOOR
STEEL CHASSIS
8
WARNING
DO NOT INSTALL IN SLEEPING ROOM
CAUTION
ROOF MUST BE MAINTAINED.
PEDESTAL
BOLT
ELECTRICALLY
GROUNDED TO CHASSIS
USSC