Uniden XS 1410 Owner's Manual

Uniden america corporation cordless telephone owner's manual
Hide thumbs Also See for XS 1410:

Advertisement

XS1410
Owner's Manual
1410 OM.indd 1
3/6/08 2:01:28 PM

Advertisement

Table of Contents
loading

Summary of Contents for Uniden XS 1410

  • Page 1 XS1410 Owner’s Manual 1410 OM.indd 1 3/6/08 2:01:28 PM...
  • Page 2: Controls And Functions

    262,144 digital security codes for the handset and base. Also, the AutoSecure feature electronically locks your phone when the handset is charging in the base. For more information on Uniden products and accessories, be sure to visit our web site: www.uniden.com.au or www.uniden.co.nz Controls and Functions .
  • Page 3: Installing The Phone

    Included with Your Phone • Base Unit • Handset • AC Adapter • Rechargeable Battery •Telephone Cord • This owner’s manual Terminology Throughout this manual, terms such as Standby and Talk are used. Below is the terminology explanation. • Talk - The handset is off the base and [talk] has been pressed, enabling a dial tone. •...
  • Page 4: Install The Rechargeable Battery Pack Into The Handset

    Then place the battery case cover back on the handset by sliding it upwards until it clicks into place. NOTE: For optimum performance, use only the Uniden Battery (BT-905s) supplied with your phone. C. Connect the base unit and charge the handset 1) Connect the AC adapter to the DC IN 9V jack and a standard 240V AC wall outlet.
  • Page 5 Talk and Standby Times With average use, your handset battery provides approximately 6 hours of talk time and approximately 12 days of standby time. When your handset is not being used and is left off of their charging cradle, the battery will gradually discharge. You can achieve optimum battery life and performance by returning the handset to the charging cradle after each use.
  • Page 6: Using Your Phone

    Using Your Phone Making and Receiving Calls Making a call 1) Pick up the handset from the base. 2) Press [talk]. The talk/batt low LED flashes and turns on. 3) Listen for the dial tone. 4) Dial the number. Receiving a call If the handset is in the base, simply remove the handset from the base.
  • Page 7: Find Handset

    Find Handset To locate the handset, press [find] on the base. The handset will beep for 60 seconds. The beeping will stop when any handset key is pressed, when it is returned to the base, or when [find] is pressed. The handset will also stop beeping automatically when an incoming call is received.
  • Page 8: Using The Speed Dial Memory

    If this happens, a new security code is set automatically next time the battery pack is charged. Warning! Uniden DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOT expose this unit to rain or moisture.
  • Page 9: Troubleshooting

    DO NOT use a microwave oven to speed up the drying process. This will cause permanent damage to the handset, base and the microwave oven. After following these steps, if your cordless telephone does not work, please visit our website www.uniden.co.au or www.uniden.co.nz Suggestion outlet.
  • Page 10: One Year Limited Warranty

    Warranty only available in original country of purchase. ELEMENT OF WARRANTY: Uniden warrants to the original retail owner for the duration of this warranty, its XS1410 Cordless Phone (herein after referred to as the Product), to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below.
  • Page 11 In the event that the Product does not conform to this warranty, the Product should be shipped or delivered, freight pre-paid, with evidence of original purchase (e.g. a copy of the sales docket), to the warrantor at: UNIDEN AUSTRALIA PTY LIMITED SERVICE DIVISION 345 Princes Highway,...
  • Page 12 © 2008 Uniden Australia Pty Limited/Uniden New Zealand Limited Printed in China UPZZ01129ZZ(0) 1410 OM.indd 11 3/6/08 2:01:33 PM...

Table of Contents