Using Two Way Communication Between The Handsets; Anywhere Without The Base (Directlink) - Uniden DSS 2455 Quick Start Manual

UP308BH (DSS2465) ENG OM 1/14/05

USING TWO WAY COMMUNICATION BETWEEN THE HANDSETS

ANYWHERE WITHOUT THE BASE (DIRECTLINK)

To use this feature, you must enter the two handsets into the DirectLink mode first.
To enter the DirectLink mode
• During DirectLink mode, batteries use time when fully charged is as follows:
- Up to 7 hours continuous use.
- Up to 24 hours in the standby mode.
• Placing the handset in the cradle causes the handset to exit the DirectLink mode.
DirectLink call
1) When the phone is in the DirectLink standby mode,
press the DirectLink soft key (example of DirectLink
from handset #1).
2) Select the party by pressing the number keys (1-4).
Your handset will page the other handset.
3) On the receiving handset, press
ANSWER soft key, or if Anykey Answer is On, press
any number key,
4) When you finish your conversation, press
END soft key on either handset. Return the handset to the cradle, or press the
CANCEL soft key then the OK soft key to return to normal mode.
11:48 AM Page 57
e e See page 16
or the
, or .
or
[ 57 ]