Page 1
G-code, M-code, and Setting Page 1 of 3 pages...
Page 2
IMPORTANT The G211 code is used to set an initial tool offset (X, Z or both). To use the probe arm must be lowered. Then the tool tip jogged into place about 0.25 in from the corner of the problem that corresponds to the desired tip direction. The code will either use the current tool offset if one has been called previously or the tool offset may be chosen using a T code.
Page 3
G-code, M-code, and Setting Care must be used for touching off any back working tools, to keep from hitting the spindle or the back wall of the machine. A tool and offset must be called Tnnn before running G212 , or IMPORTANT an alarm will be generated.