Toshiba PORTEGE M400 Maintenance Manual page 84

2 Troubleshooting
Procedure 2 Message Check
When the power is turned on, the system performs the Initial Reliability Test (IRT) installed
in the BIOS ROM. When the test detects an error, an error message is displayed on the screen.
Make sure of no floppy disk in the FDD. Turn on the computer and check the message on the
screen. When an OS starts from the 2.5" HDD, go to Procedure 3. Otherwise, start with Check
1 below and perform the other checks as instructed.
Check 1 If any of the following messages appear, go to Procedure 3. If the following
messages do not appear, perform Check 2.
HDC ERROR
HDD #X ERROR
Check 2 If either of the following messages appears, go to Check 3. If the following
messages do not appear, perform Check 4.
Insert system disk in drive
Press any key when ready .....
Non-System disk or disk error
Replace and press any key when ready
Check 3 Using the SYS command of the MS-DOS, transfer the system to the 2.5" HDD. If
the system is not transferred, go to Procedure 3. Refer to the MS-DOS Manual for
detailed operation.
If the following message appears on the display, the system program has been
transferred to the HDD.
System Transferred
If an error message appears on the display, perform Check 4.
Check 4 The 2.5" HDD, HD board and the connector of the System board may be
disconnected (Refer to the steps described in Chapter 4, Replacement Procedures
for disassembling the PC.). Reconnect them firmly. If they are firmly connected,
go to Procedure 3.
2-36 [CONFIDENTIAL]
or
(After 5 seconds this message will disappear.)
or
PORTEGE M400 Maintenance Manual (960-541)
2.6 2.5" HDD Troubleshooting