Additional Memory Module - Toshiba Satellite P750 Series User Manual

■
Make sure the Memory media slot indicator is out before you remove
the memory media or turn off the computer's power. If you remove the
memory media or turn off the power while the computer is accessing
the memory media, you may lose data or damage the media.
■
Do not remove the memory media while the computer is in Sleep or
Hibernation Mode. The computer could become unstable or data in the
memory media could be lost.
■
Do not remove only the miniSD/microSD Card while leaving the
adaptor in the Memory media slot.

Additional memory module

You can install additional memory into the computer in order to increase the
amount of system memory that is available. This section describes how to
install and remove optional memory modules.
■
You should place a mat beneath the computer in order to prevent the
computer's lid from becoming scratched or damaged when you are
installing/replacing the memory module. In this instance you should
avoid mats that are made of materials that hold or generate static
electricity.
■
When installing or removing a memory module, you must ensure that
you do not touch any other internal areas of the computer.
■
Insert the two memory modules into Slot A and Slot B respectively. The
computer will operate in dual channel mode.
You can access the inserted memory modules efficiently in dual
channel.
■
Use only memory modules approved by TOSHIBA.
■
Do not try to install or remove a memory module under the following
conditions.
a. The computer is turned on.
b. The computer was shut down in either Sleep or Hibernation Mode.
c. Wake-up on LAN is enabled.
d. The wireless communication function is turned on.
e. Sleep and Charge function is enabled.
■
Be careful not to let screws or other foreign matter fall into the
computer. It could cause malfunction or electric shock.
■
Additional memory module is a precision electronic component that
may be fatally damaged by static electricity. Since the human body can
carry static electricity, it is important that you discharge yourself before
touching or installing any additional memory modules. To discharge
your body's static electricity, simply touch any metal close to you with
bare hands.
■
Use a point size 0 Phillips screwdriver to remove and fasten the screws
- the use of an incorrect screwdriver can damage the screw heads.
User's Manual
Satellite P750/P755 Series
3-21