Kohler 9038 Installation Instructions

INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co.
reserves the right to make changes in product characteristics, packaging, or availability at any time without
notice.
Please leave these instructions for the consumer. They contain important information.
ROUGH-IN DIMENSIONS
Ø54
9038
INSTALLATION
For 9038
Determine a suitable location on the finished wall to install the
bracket. Take off the locking pin(2) from the bracket(1). Take out the
self-tapping screws(3) and anchors(5) from the inside of the bracket
by pulling out the plastic sleeve(4). Mark bracket base mounting hole
location on the wall. Drill two holes in the finished wall as required.
Press the anchors into the holes and screw the self-tapping screws
into the anchors through the sleeve. Tighten them by screwdriver.
Align the bulge of the bracket with the slot of the sleeve. Slide the
bracket onto the sleeve and insert the locking pin into the hole of
bracket and sleeve.
1069819-2A-B
9038 9039 9040
9039
BRACKET
58
9040
4
5
Bracket
40
1
2
2 1
3
1