Table of Contents
Advertisement
Your radio comes with two KeyCards.
To replace a lost or damaged KeyCard, con-
tact your Blaupunkt dealer.
If you use two KeyCards, the settings for the
first KeyCard are also used for the second
KeyCard. You can, however, store the follow-
ing functions individually:
Preset stations, beep volume, equaliser set-
tings.
In addition, the last values set for frequency
range, station, scanning time, and switch-on
volume remain stored.
This way, after you insert your KeyCard, the
unit will always be in the basic configuration
that you have chosen.
Press the
button to open the operat-
ing panel 1.
Insert the KeyCard as shown in the pic-
ture (Arrow 1) with the contacts facing
downward.
Use the slide to push the card carefully
in the direction shown by the arrow (2)
as far as it will go.
3
Close the operating panel (Arrow 3).
1
Note:
If a card that does not belong to the unit (for
example, a bankcard) is inserted, the display
will read "Wrong KC".
Remove the incorrect card and insert a card
that the unit is able to recognise.
To unlock the operating panel,
button 1.
Press the
This will open the operating panel.
Use the "slide" to push the card to the
right as far as it will go.
Remove the card from the operating
panel.
Close the operating panel.
Note:
To discourage theft, always remove your Key-
Card before exiting the vehicle and leave the
operating panel open.
For reasons of safety, the operating
panel must be closed whenever the vehi-
cle is in motion.
Note:
No more than two KeyCards can be used for
each unit.
If you already have two KeyCards for your unit
and you "train" a third KeyCard, then the unit
can no longer be operated with the KeyCard
that was not used in training.
7
Advertisement
Table of Contents
