Charge Battery; Remove/Attach Belt Clip - Philips SE4552B/17 User Manual

Place the batteries in the correct
polarity as indicated and replace the
cover.

6.3.2 Charge battery

Warning
The handset must be charged for at least
24 hours before using it for the first time.
When the battery level becomes low, the
low battery sensor warns you by blinking
the battery icon. If this occurs during a
conversation, an alert tone sounds to
inform you that the battery is low. If the
battery level becomes exceedingly low,
the phone automatically switches off
shortly after the icon starts blinking and
any function in progress will not be
saved.
Place the handset on the charging
cradle of the base station. A beep is
emitted if the handset is placed
correctly.
The battery icon
blinks during charge.
The battery icon
when the handset is fully charged.
Note
Optimal battery life is reached after 3
cycles of complete charging (over 15
24
on the display
becomes steady
hours) and discharging, allowing
approximately 12 hours of talk-time and
150 hours of stand-by time.
The indoor and outdoor range of the
phone is up to 50 metres and 300 metres
respectively. When the handset moves
beyond the operation range, the antenna
icon will blink.
Tip
When you reach the range limit the
conversation may become crackly. Move
closer to the base.
6.4

Remove/Attach belt clip

A belt clip allows you to carry your
handset on your belt.
To remove the belt clip, simply pull
the clip away from the handset.
To attach the belt clip to your
handset, fit the tabs on the belt clip
into the slots at the back of the
handset and push into place.
Getting started