Tax Table Programming - TEC FS-1450 Owner's Manual

TAX TABLE PROGRAMMING

A maximum of four tables can be programmed (Tax 1, Tax 2, Tax 3, Tax 4) in accodance with installa-
tion of [TX1/M], [TX2/M], [TX3/M], [TX4/M] keys.
After Financial Daily Reset
CONDITION
Mode Lock: SET
OPERATION
TYPE 1: TAX 1 FULL BREAKS (COMBINATION OF NON-CYCLIC AND CYCLIC BREAKS)
| Max. amount non-taxable | [TX1/M]
| Max. amount for 1¢ tax levied | [TX1/M]
| Max. amount for 2¢ tax levied | [TX1/M]
Repeat up to the "A" Break
| Max. amount for N¢ tax levied | ... "A" Break (Non-cyclic Break Limit)
[ST] (to indicate the completion of Non-cyclic Breaks)
| Max. amount for N + 1¢ tax levied | [TX1/M] (beginning of Cyclic Breaks)
| Max. amount for N + 2¢ tax levied | [TX1/M]
Repeat up to the "B" Break ("B" Break - "A" Break = Multiple of $1.00; max. $9.00)
[AT/TL] (to complete this tax table programming)
NOTE: The break amount entry must be a maximum of 4 digits (1 to 9999 resulting in $0.01
to $99.99)
TYPE2: TAX 1 COMBINATION OF NON-CYCLIC BREAKS AND % RATE
First set the breaks up to the "A" Break entry and the [ST] key depression as shown in TYPE 1.
| TAX RATE applied when exceeding the "A" Break amount |
(0.0001 to 99.9999 (%); use the [ . ] key if a decimal portion is contained. Examples:
set 5% , enter 5. To set 5.26%, enter 5.26. The fraction of the amount resulting from this %
rate calculation will be rounded off.)
[AT/TL] (to complete this tax table programming)
TYPE3: TAX 1% RATE ONLY
0 [TM1/M] [ST] | TAX RATE |
(The description for the TAX RATE in
TYPE 2 is also applied to this case.)
– 62 –
[AT/TL]
EO1-11097
To