Toshiba RAS-10YAV-E Service Manual page 67

No. Part name
Replacement 1) Cut the sensor 100 mm longer than old one.
11
of temperature 2) Cut the protective tube after pulling out it
sensor for
servicing only 3) Move the protective tube toward the thermal
Common service
parts of sensor 4) Pass the stripped part through the thermal
TO, TS, TE, TD
5) Cut the old sensor 100 mm length on the
6) Tear the lead wire in two on the connector
7) Twist the leads on the connector and sensor
8) Move the thermal constringent tubes toward
9) Wind the attached color tape round the both
10)Fix the sensor again.
NOTES :
1) Store the joint part of the sensor and the
2) Never joint them near the thermal sensor
3) When replacing the sensor using the colored
These are parts
for servicing
sensors.
Please check
that the accesso-
ries shown in the
right table are
packed.
Procedure
(200 mm).
sensor side and tear the tip of lead wire in
two then strip the covering part.
constringent tube.
connector side, and recycle that connector.
side and strip the covering part.
sides, and solder them.
the soldered parts and heat them with the
dryer and constring them.
terminals of the protective tube when colored
protective tube is used.
connector in the electric parts box.
part. Otherwise it would cause insulation
inferiority because of dew drops.
protective tube, wind the color tape matching
the color of that tube.
Parts name
1 Sensor
2 Sensor Spring (A)
3 Sensor Spring (B)
4 Thermal constringent tube
5 Color tape
6 Terminal
– 67 –
Remarks
Thermal
Connector
sensor part
200
Thermal
constringent tube
Cutting here
100
Soldered part
Dryer
Winding the color tape
Q'ty Remarks
1 Length : 3m
1 For spare
1 For spare
3 Including one spare
1 9 colors
3
Cutting here
100
Cutting here