Making Adjustments; Leveling The Deck; Seat Adjustment - Toro LX420, LX460 Operator's Manual

Toro lawn tractor operator's manual
Hide thumbs Also See for LX420, LX460:
Table of Contents

Advertisement

SECTION 8: MAKING ADJUSTMENTS
WARNING:
adjustments while the engine is running,

Seat Adjustment

To adjust the position of the seat, loosen the two knobs
on the bottom of the seat. See Figure 9. Slide the seat
forward or rearward as desired. Retighten the two
knobs.
Knobs
Figure 9

Leveling the Deck

NOTE:
Check the tractor's tire pressure before
performing any deck leveling adjustments. Refer to
Tires on page 26 for information regarding tire pressure.
Front To Rear
The front of the cutting deck is supported by a stabilizer
bar that can adjusted to level the deck from front to rear.
The front of the deck should be between 1/4-inch and
3/8-inch lower than the rear of the deck. Adjust if
necessary as follows:
With the tractor parked on a firm, level surface,
place the deck lift lever in the top notch (highest
position) and rotate the blade nearest the discharge
chute so that it is parallel with the tractor.
Measure the distance from the front of the blade tip
to the ground and the rear of the blade tip to the
ground.
The first measurement taken should be between
1/4" and 3/8" less than the second measurement.
Never attempt to make any
Determine the approximate distance necessary for
proper adjustment and proceed, if necessary, to the
next step.
From the front of the tractor, loosen the outermost
hex lock nut on the end of the deck hanger rod. See
Figure 10 or Figure 11.
Tighten the inner hex nut front against the front
hanger bracket to raise the front of the deck; loosen
the hex nut to lower the front of the deck. See
Figure 10 or Figure 11.
Retighten the two lock nuts against the inner hex
nuts when proper adjustment is achieved.
19
LX 420
Figure 10
LX 460
Figure 11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

13ax60rg74413ax60rh744Lx420Lx460

Table of Contents