Timex 120-095007 NA Instruction Manual

THANK YOU FOR PURCHASING YOUR TIMEX® WATCH.
EXTENDED WARRANTY
Available in U.S. only. Extend your warranty for an additional 4 years from date of purchase
for $5. You can pay with AMEX, Discover, Visa or MasterCard by calling 1 800-448-4639 during
normal business hours. Payment must be made within 30 days of purchase. Name, address,
telephone number, purchase date, and 5-digit model number required. You can also mail a
check for $5 to: Timex Extended Warranty, P.O. Box 1676, Dept. EF, Little Rock, AR 72203.
Please read instructions carefully to understand how to operate your Timex® watch.
Your model may not have all of the features described in this booklet.
• Time and date display • Daily alarm • Chronograph • Hourly chime
MODE
INDIGLO®
BUTTON
Press MODE to set time, date and alarm or enter Chrono Mode. Press INDIGLO® button to
illuminate watch face. In any mode, press MODE to view time display. Press any button to stop
alarm beeps.
A. Press and hold MODE until HOURS digits flash (you'll be in Alarm Mode). Press MODE again
to enter TIME mode. SECONDS digits will flash.
B. Press ADJUST to set SECONDS to zero.
C. Press START/STOP to select MINUTES.
D. Press ADJUST to change.
E. Repeat to set HOURS, MONTH, DATE, and DAY of WEEK. Go through 12 hours to set AM
or PM.
F. Press MODE when done.
G. To display DATE from TIME display, press START/STOP.
H. With DATE displayed, press and hold START/STOP, then press ADJUST to change display
between DATE-MONTH and MONTH-DATE.
I. With TIME displayed, press and hold ADJUST, then press MODE to switch between 12- and
24-hour format.
A. Press and hold MODE until HOURS digits, DAY, and A or P (for AM or PM) flash.
B. Press ADJUST to change HOURS digits. Go through 12 hours for AM or PM.
C. Press START/STOP to select MINUTES.
D. Press ADJUST to change. Press MODE when done.
E. Press and hold ADJUST, then press START/STOP to turn chime on/off. Press START/STOP
again to turn alarm on/off. Release START/STOP when done.
When alarm time is reached, watch will beep until a button on the watch is pushed. Alarm will
repeat every 24 hours until deactivated.
or will appear in display when alarm is on.
hourly chime is on.
Chronograph will count up to 24 hours. Lap times are not stored. After 40 minutes chrono
display changes from seconds to minutes.
A. With time displayed, press MODE to select Chrono Mode.
B. Press START/STOP to start.
C. Press ADJUST to view lap time. Press again to resume lap timing.
D. Press START/STOP to stop timing. Press ADJUST to reset chrono to zero.
E. Repeat for successive laps.
Press INDIGLO® button to activate light.
Electroluminescent technology used in the INDIGLO® night-light illuminates watch
face at night and in low light conditions.
If your watch is water-resistant, meter marking or (
Water-Resistance Depth
30m/98ft
50m/164ft
*pounds per square inch absolute
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER
WATER.
1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
Register your product at
www.timex.com
W-163
120-095007
FEATURES
BASIC OPERATIONS
START/
MODE
STOP
INDIGLO®
ADJUST
BUTTON
TIME AND DATE
ALARM AND HOURLY CHIME
CHRONOGRAPH
INDIGLO® NIGHT-LIGHT
WATER RESISTANCE
p.s.i.a.* Water Pressure Below Surface
NA
PM
W R 5 0 M
or will appear in display when
) is indicated.
60
86
START/
STOP
ADJUST