Assembly - Thermos 461240504 Product Manual

CAUTION
NATURAL HAZARD • SPIDERS
FACT: Sometimes spiders and other small insects climb into
the burner tubes attached to the burners. The spiders spin
webs, build nests and lay eggs. The webs or nests
can be very small, but they are very strong
and can block the flow of gas. Clean
burners prior to use after storing, at the
beginning of grilling season or after a period
of one month not being used.
Spider guards are on the air intakes in an effort to reduce this
problem, but it will not eliminate it! An obstruction can result
in a "flashback" (a fire in the burner tubes). The grill may still
light, but the obstruction does not allow full gas flow to the
burners.
IF YOU EXPERIENCE THE FOLLOWING:
1. Smell gas.
2. Burner(s) will not light.
3. A small yellow flame from burner (should be blue).
4. Fire coming from around or behind control knob.
STOP!
Immediately turn off gas at LP tank!
SOLUTION:
Wait for grill to cool.
Follow the " Cleaning The Burner Assembly
Clean burners often. Use a 12" pipe cleaner to clean out the
burner tubes. You may also force a stream of water from a
hose nozzle through burner tubes to clean them.
Storing Your Grill
• Clean cooking grates.
• Store in dry location.
• When LP tank is connected to grill, store outdoors in a well-
ventilated space and out of reach of children.
• Cover grill if stored outdoors. Choose from a variety of grill
covers offered by manufacturer.
• Store grill indoors ONLY if LP tank is turned off and
disconnected, removed from grill and stored outdoors.
• When removing grill from storage, follow "

Assembly

" instructions before starting grill.
Cleaning The Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1.
2. Remove cooking grates, flametamers, grease tray and
3. Remove cotter pins from beneath each burner "foot" using a
4. Carefully lift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
5. Wire brush entire outer surface of burner to remove food
6. Clean any blocked ports with a stiff wire such as an open
7. Check burner for damage, due to normal wear and corrosion
VERY IMPORTANT: Burner tubes must reengage valve
" instructions.
8. Carefully replace burners.
9. Replace cotter pin beneath each burner.
10. Replace grease tray, grease receptacle, flametamers, and
Cleaning the Burner
Turn gas off at control knobs and LP tank.
grease receptacle.
screwdriver or needle nose pliers.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Run the hook through each burner
tube and burner several times.
(B) Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brush through each
burner tube and burner several times.
(C) Wear eye protection:
the burner tube and out the burner ports. Check each
port to make sure air comes out each hole.
residue and dirt.
paper clip.
some holes may become enlarged. If any large cracks or
holes are found replace burner.
openings. See illustrations below.
cooking grates.
Burner Valve
Use an air hose to force air into
461240504 • 21