Confirming The Result; Locate And Search Functions; Direct Locate Function - Tascam DP-004 Owner's Manual

the way left (bounced to track 1 or 3) or all the way
right (track 2 or 4). Use the
adjust the overall level.
6 After returning to the start of the song, press the
playback (Á) key while pressing and holding the
record (–) key to start the bounce.

Confirming the result

Raise the bounce destination track
other track knobs all the way down) and
LEVEL
the knob, and start playback from
MASTER LEVEL
the beginning of the song. If you are not satisfied
with the result because, for example, the balance
between instruments is poor, or the pan settings are
wrong, use the undo function (see "Undoing the last
operation (single undo)" on page 66).
If you are satisfied with the result, press the
key to open the
MODE
RECORDER MODE
select , then press the
MUL TI TRACK
to the Home Screen.
After bouncing tracks, you can make new recordings
over the other tracks.
knob to
MASTER LEVEL
knob (turn
LEVEL
REC
screen and
key to return
HOME
7–Recorder Functions
TIP
If it is possible that you might need the original tracks at
some later time, back-up the track data to a computer or
copy the song before bouncing (see "Backing-up songs"
on page 94 and "Connecting with a computer" on page
92).

Locate and search functions

Direct locate function

This is the way to locate a specific position in a
song. The current recorder position is shown at
the top of the display as "hours: minutes: seconds:
frames" (there are 30 frames per second). You can
move the transport location to a specific time by
inputting it here.
1 Use the key to move the cursor (underline)
F1 ( )
D IGIT
between the time divisions. You can edit the value
at the cursor positions. The seconds are selected in
the following figure.
71
TASCAM DP-004